Snapper MZM5203M, MZM2301KH, ZM5202M, ZM6102M Parking Brake Adjustment

Page 20

Section 5 - ADJUSTMENTS & REPAIR

WARNING

DO NOT attempt any maintenance, adjustments or service with engine running. STOP engine. STOP blades. Set brake. Remove key. Remove spark plug wires and secure away from spark plugs. Engine and components are HOT. Avoid serious burns, allow sufficient time for all parts to cool.

5.3PARKING BRAKE ADJUSTMENT

1. The parking brake can be adjusted by removing the rod from the lever and rotating it clock-wise to increase brake tension. When properly adjusted, the parking brake lever should require 18 to 22 pounds of force to set the brake. If this adjustment does not result in proper braking action contact your authorized SNAPPER dealer for corrective action. See Figure 5.3.

5.4ENGINE ADJUSTMENTS & REPAIR

Refer to the engine owner’s manual for engine adjustments and/or repairs.

WARNING

Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury. DO NOT use a cutting blade that shows signs of excessive wear or damage.

5.5MOWER BLADE REPLACEMENT

5.5.1.BLADE WEAR LIMITS

1. Inspect blade frequently for signs of excessive wear or damage. See Figure 5.4.

WARNING

Do not operate this machine if the brakes are not functioning properly!

PARKING

BRAKE

LEVER

PARKING

BRAKE

ROD

FIGURE 5.3

NEW BLADE

WEAR LIMIT (NOTCH STARTS)

DANGEROUS CONDITION!

DO NOT USE ON MOWER!

REPLACE WITH NEW BLADE.

FIGURE 5.4

21

Image 20
Contents MID Mount Z-RIDER Zero Turning Hydro Drive Series Mower UnitFrom Previous Column Always begin forward motion slowly and with cautionOperation Important Safety Instructions Table of Contents Introduction NomenclatureSafety Messages and Symbols Safety Messages and Symbols Operating Instructions PRE-START Check ListStarting & Stopping ENGINE, BLADES, Parking Brake Starting EngineStopping Engine Starting Mower BladesParking Brake OPERATION- Motion Controls 3.4.1. Driving Machine Cutting Height AdjustmentStopping Machine Service After First 5 Hours Check Mower Blade Change Engine OILCheck Mower Drive Belt After Every 25 Operating HoursBefore Operating Machine Annually END of Each SeasonDeck Removal Power Transfer Shaft Removal Deck Removal from previousNeutral Position Adjustments Side to Side LevelMower Deck Adjustment Levelness Front to Rear LevelMower Blade Replacement Blade Wear Limits Parking Brake AdjustmentEngine Adjustments & Repair Mower Drive Belt Replacement Belt ReplacementBlade Sharpening Belt RemovalBattery Service Battery Battery RemovalBattery Installation Do not Overfill Battery TestingNEW Battery Preparation Mower Spindles Field Serviceable Spindles Bearing ReplacementProblem Probable Cause Corrective Action Trouble Shooting on NextTractor Will Not Move Service Performed Each MAINTENANCE/REPLACEMENT Parts100 USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page MID Mount Z-RIDER Zero Turning Hydro Drive Series