Snapper NZMX30614KH, NZMX32734BV specifications Safety Instructions & Operators Manual for

Page 40

Safety Instructions & Operator's Manual for

LARGE FRAME

MID-MOUNT Z-RIDER

ZERO TURNING

HYDRO DRIVE

SERIES 4

IMPORTANT

Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone: (1-800-935-2967).

!WARNING

BATTERY POSTS, TERMINALS AND RELATED ACCESSORIES CONTAIN LEAD AND LEAD COMPOUNDS, CHEM- ICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRO- DUCTIVE HARM. WASH HANDS AFTER HANDLING.

!WARNING

ENGINE EXHAUST, SOME OF ITS CONSTITUENTS, AND CERTAIN VEHICLE COMPONENTS CONTAIN OR EMIT CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER OR OTHER REPRODUCTIVE HARM.

COPYRIGHT © 2006

SNAPPER - A DIVISION OF SIMPLICITY MFG., INC. ALL RIGHTS RESERVED

MANUAL No. 7100718 (Rev. 1, 7/20/2006) TP 100-5176-R1-HZ-N

40

Image 40

Contents Safety Instructions & Operators Manual for Important Safety Instructions Preparation Maintenance Table of Contents Introduction FamiliarizationNomenclature Safety Messages and Symbols Safety Messages and Symbols Attencion Operating Instructions PRE-START Check ListStarting & Stopping ENGINE, BLADES, Parking Brake Starting EngineStopping Engine Starting Mower BladesStopping Mower Blades Parking BrakeCutting Height Adjustment OPERATION- Motion Controls 3.4.1. Driving MachineSafety Interlock System Checks Stopping MachineFolding the Roll BAR Protective Structure Engine Must not Start ifService After First 5 Hours Maintenanceoperating InstructionsCheck Mower Blade Check Mower Drive Belt 1. Lower deck to lowest setting After Every 25 Operating Hours 4.3.1. EngineBefore Operating Machine Annually END of Each SeasonDeck Removal Hydraulic Fluid Filters System Purging Before Performing Filter MaintenanceImportant Refer to Section Hydraulic ADJUSTMENTSOPERAINGINSTRUCTIONS& Repair Neutral Position AdjustmentsNeutral Position Adjustments From Previous Parking Brake Adjustment Traction Belt Replacement Operaadjustmentsingin TRUCTIONS&REPAIRTraction Belt Tension Tracking Adjustment Mower Drive Belt ReplacementBelt Replacement Belt RemovalBlade Sharpening Battery Installation 10BATTERY Battery RemovalBattery Charging Battery Condition Chart Battery Testing11HYDRAULIC SYSTEM, Purging SectionTROUBLESHOOTING3 Operating Instructions Problem Probable Cause Corrective ActionCutting Grass SERVICEection3 SCHEDULE- OP Rating Instructions Service REF. Number EachMAINTENANCE/REPLACEMENT Parts Performed USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Safety Instructions & Operators Manual for