Section 53 - ADJUSTMENTSOPERAINGINSTRUCTIONS& REPAIR
5.1NEUTRAL POSITION ADJUSTMENTS (Continued From Previous Page)
12. With motion control levers remaining in the neutral lock position, See Figure 3.7, hold connecting rod up to the activation assembly and check length of rod. Tie rod end bolt must align with the activation assembly. If bolt is not aligned with the activation assembly, adjust tie rod. Loosen jam nut that secures tie rod. Rotate tie rod in or out to align with hole in activation assembly. Repeat step for other hydro pump. See Figure 5.4.
HYDRO PUMP |
| HYDRO |
ACTIVATION |
| PUMP |
ASSEMBLY |
|
|
|
| |
|
|
|
TIE ROD END
BOLT IS SHOWN
MISALIGNED
WITH ACTIVATION
ASSEMBLY
| LOOSEN NUT AND |
| ROTATE TIE ROD END IN |
| OR OUT TO ALIGN WITH |
TIE ROD END | ACTIVATION ASSEMBLY |
BOLT IS SHOWN
ALIGNED WITH
HOLE
FIGURE 5.4
13.Once tie rod end bolt is aligned with activation assembly insert into hole and reinstall washers and nut that secure bolt to assembly. Tighten securely. Tighten tie rod jam nut securely.
14.Start engine, disengage parking brake, and check rotation of the rear wheels.
15.Reinstall both hydro pump fans. Reinstall washer and bolt. Tighten bolt securely.
16.Reinstall pump fan cover plate and tighten hardware securely. Replace any fuel line wire ties that were removed.
5.2MOWER DECK & COMPONENT ADJUSTMENTS 5.2.1. MOWER DECK ADJUSTMENT (LEVELNESS) SIDE to SIDE and FRONT to REAR
Before making deck leveling adjustments, inflate rear tires to 12 PSI and front tires to 25 PSI. When adjust- ed correctly, the deck will be level side to side within 1/8”, have a low cut setting of approximately 1” (1 1/4" for 61 deck) and the blades pitched approximately 3/16” higher at the rear.
1. Place machine on a smooth level surface.
2. Check side to side level by rotating blades until tips are pointing to the sides of the deck. Check the meas- urement of outside blade tips to the ground on both blades. The measurement of each of the outside blade tips should be within 1/8” of each other. If measure- ment of the blade tips is not within 1/8”, adjustment should be made.
3. Set the mower deck to the transport position. Refer to Section “Cutting Height Adjustment”.
4. Relieve tension on deck lift assist spring by loosen- ing nut on eyebolt. Refer to Section “Removing Deck”. 5. Place 1” blocks (1 1/4" for 61 deck) under the front and rear edge of the mower deck.
6. Insert stop pin into lowest cutting height, and lower deck onto blocks.
7. Loosen the top nuts that secure both front deck support eyebolts. Adjust bottom nuts until eyebolts are tight, then retighten top nuts. Torque to 20 to 30 ft. lbs. See Figure 5.5.
FRONT
LIFT ARM
LOOSEN TOP NUT
DECK HANGER
BRACKET
ADJUST BOTTOM
NUT UNTIL EYEBOLT
IS TIGHT
FIGURE 5.5
21