Snapper Steel Deck Commercial Walk Behind Mowers manual

STEP 10: Install the grass bag adapter and secure to the side of the deck with the two 5/16-18 nuts (P/N 9- 0951) provided in the hardware bag. See Figure 14.

SECURE ADATER TO

DECK WITH NUTS

	SUPPORT ROD
NUT
		ROPE GUIDE

FIGURE 15

FIGURE 14

6 MM HEX BOLT AND FLAT WASHER

SUPPORT ROD ON TOP OF ROPE GUIDE PULLEY

STEP 11: KAWASAKI ENGINE. Attach support rod to deck adapter by first removing the nut and bolt at the rope guide pulley. Reassemble with the support rod underneath the pulley and the flattened end of the rod towards the engine. Attach the support rod to the top of the engine. Remove the nut and washer from the right rear corner of the recoil housing as shown. Place the support rod over the threaded engine stud. Install nut only (washer not needed) and re-tighten the nut. See Figure 15.

STEP 11: ROBIN 4-CYCLE ENGINE. The installation of the support rod on the Robin 4-cycle engine is saimilar to the installation on the Kawasaki engine described above. On the Robin installation, the rope guide end of the support rod is on top of the pulley and the flattened end is attached to the engine with a 6 MM hex bolt and flat washer (included in the hardware bag with the mower). A support rod is not required on mowers equiped with Robin 2-cycle engines. See Figure 16.

FIGURE 16

4