Snapper WMR216517B, WMRP216517B important safety instructions Operation

Page 3

IMPORTANT SAFETY INSTRUCTIONS

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage.

6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

10.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

11.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

12.DO NOT operate mower without the entire grass catcher or guards in place. DO NOT point discharge at people, passing cars, windows or doors.

13.Slow down before turning.

14.Watch out for traffic when near or crossing roadways.

15.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

3

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

12.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Steel Deck Walk Mowers M Model Series Engine Type Series Designation Engine Horse PowerImportant Safety Instructions Operation Table of Contents Nomenclature IntroductionStarting & Operation 2.2.1. Engine & Blade PRE-START Check ListStopping Handle Height AdjustmentCutting Height Adjustment Starting & OperationRecycling Operation BAG Slider Fold BAG AS Shown Install Discharge Deflector Slide Deflector Slot Under NUT On Next Service After First 5 Hours 3.2.1. Change Engine OILImportant Drain fuel tank before tipping mower Check Grease Level in TransmissionCheck Engine Drive Belt Service AnnuallyStorage Procedure Check Mower BladeMower Blade Replacement 4.1.1. Standard Blade Wear Limit Blade SharpeningNinja Blade Wear Limit Wheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementReplacing Rubber Driven Disc Replacing Bearing In Driven Disc Assembly Engine Drive Belt Replacement Stretch Type Belts Belt ServicePulley Position Transmission Poly-V Belt ReplacementProblem Probable Cause Corrective Action Troubleshooting100 Service Performed EachClean Sponge Element Engine Manual MAINTENANCE/REPLACEMENT PartsDisclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Steel Deck Walk Behind Mowers M Model Series
Related manuals
Manual 46 pages 20.32 Kb

WMRP216517B, WMR216517B, WMRP216517B specifications

The Snapper WMRP216517B, also known as WMR216517B, is a powerful walk-behind mower designed for performance, durability, and user convenience. This mower is favored by both homeowners and professionals who require a reliable and efficient cutting solution for medium to large-sized lawns.

One of the main features of the Snapper WMRP216517B is its robust engine. Powered by a reliable 163cc OHV engine, this mower delivers plenty of power for cutting through thick grass and tackling uneven terrain. The self-propelled drive system offers ease of operation, allowing users to maintain a steady pace without exerting too much effort. This feature is particularly beneficial for those who may find traditional push mowers challenging to operate over long distances.

The WMR216517B is equipped with a 21-inch steel cutting deck, which provides an optimal balance between maneuverability and cutting efficiency. This deck size is perfect for efficiently maintaining lawns without being overly cumbersome. The mower also boasts an adjustable cutting height, ranging from 1 inch to 4 inches, allowing users to customize their mowing experience based on grass type and growing conditions.

Another notable characteristic of the Snapper WMRP216517B is its advanced grass management system. It features a three-in-one capability, allowing users to choose between mowing, bagging, or mulching grass clippings. The mulch plug ensures that clippings are finely chopped and returned to the soil, providing natural nutrients to promote a healthier lawn.

User comfort is also prioritized in the design of the WMR216517B. It comes with adjustable ergonomic handles, which can be tailored to the user's height for maximum comfort during operation. The folding handle design makes storage simple, especially in tight spaces.

Additionally, this mower features easy-start technology that reduces starting friction and enhances reliability, ensuring that users can get to mowing without frustrating delays.

In summary, the Snapper WMRP216517B and its variants are excellent choices for anyone in need of a dependable walk-behind mower combining power, versatility, and user-friendly features, making lawn care a more enjoyable task.
Top Page Image Contents