Snapper YZ145333BVE, YZ145383BVE Service Annually, Storage OUT of Season

Page 13

Section 3 - MAINTENANCE

WARNING

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage.

3.Parking Brake Pivot Bushings

a.Make sure fuel cap is on tight. Turn fuel shut off valve (If equipped) to the “CLOSED” position. Start engine and allow it to run until engine runs out of fuel. Close vent on fuel filler cap.

b.Remove key from ignition switch.

c.Remove spark plug wire(s) and secure away from spark plug(s).

d.Carefully stand YARD CRUISER on rear bumper.

e.Lubricate both pivot bushings with three shots general purpose grease from grease gun. See Figure 3.7

YARD CRUISER SHOWN WITH

DECK REMOVED. DECK

REMOVAL NOT NECESSARY

FOR LUBRICATION.

LUBRICATE BOTH PIVOT

BUSHINGS

FIGURE 3.7

3.4SERVICE - ANNUALLY

Perform all maintenance as described in the maintenance schedule.

3.4.1. Engine

Service engine according to engine owner’s manual.

3.4.2. Air Filter

Refer to engine owner’s manual for service instructions.

3.4.3. Oil Filter

Refer to engine owner’s manual for service instructions.

3.4.4. Engine Oil

Refer to engine owner’s manual for service instructions.

3.4.5. Transaxle

IMPORTANT: DO NOT try to open reservoir cap at any time. The transaxle is maintenance free. The transaxle does not require any fluid or any service. If there is any problem: leakage, malfunction or etc. return the Yard Cruiser immediately to the nearest authorized Snapper dealer for service.

3.4.6. Fuel Filter

Service fuel filter as instructed below. Turn key to “OFF” position. Engine MUST be stopped and MUST be cold before removing filter. Turn fuel shut off valve (If equipped) to the “CLOSED” position or perform filter change when fuel tank and fuel line are empty.

1.Remove hose clamps from fuel filter.

2.Remove fuel lines from filter. Discard filter.

3.Install new fuel filter. Reinstall hose clamps. See Figure 3.8.

NEW FUEL FILTER

PART NO. 1-4359

HOSE CLAMPS

FIGURE 3.8

3.5 STORAGE (OUT OF SEASON)

If desired, the YARD CRUISER can be stored on the rear bumper. Perform the following procedures to insure the YARD CRUISER will operate properly when taken out of storage.

1.Thoroughly clean the YARD CRUISER by removing all grass clippings and debris.

2.Perform maintenance and lubrication as described in the previous sections.

3.Drain fuel from fuel tank.

4.Start engine and allow it to run until engine runs out of fuel. This allows the carburetor and fuel system to remain clean during storage.

5.Remove battery. Refer to Section “BATTERY REMOVAL AND STORAGE”.

6.Close vent on fuel filler cap. Remove key.

7.Carefully stand YARD CRUISER on rear bumper in desired location for storage.

13

Image 13
Contents Yard Cruiser Important Safety Instructions Operation Table of Contents Left Console View Right Console ViewIntroduction NomenclaturePRE-START Check List Operating InstructionsOperation Starting & Operation Engine Electric StartStopping Mower BladeEngine Parking BrakeCutting Height Adjustment Change Engine OIL Service After First 5 HoursCheck Mower Blade Single Blade DeckService Every 25 Operating Hours Underside View of 33 Deck Mower Blade Spindle LubricationYard Cruiser Lubrication 1. Front Wheel Bearings Front Caster Wheel Pivot ShaftEngine Air Filter Oil Filter Engine Oil Transaxle Service AnnuallyStorage OUT of Season Engine Adjustments & Repair Neutral Position AdjustmentsLower View Front of Mower Is Shown From this Angle Belt Replacement Mower Drive Belt AdjustmentBelt Removal DeckBelt Replacements Blade Brake AdjustmentAdjusting Mower Blade Idler ARM and Belt Guide Detail+ 1/16 Adjusting the 33 Deck BladeDeck Shown Front or Rear View of DeckMower Deck Timing ROD Front to Rear Deck Pitch 38 DecksMower Blade Replacement 4.4.1. Blade Wear Limits Wheel Brake AdjustmentBlade Sharpening Battery Battery Removal Mower Blade Replacement 4.4.3. Blade ReplacementBattery Service Battery StorageNEW Battery Preparation 1. Remove battery from carton Battery TestingTrouble Shooting on Next Problem Probable Cause Corrective ActionRider Will Not Move Or MAINTENANCE/REPLACEMENT Parts Service Performed Each100 USE HRS SeasonDisclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Service Notes Yard Cruiser Hydro Drive Series