Snapper 1807-0 owner manual Remove Pressure Washer from Carton, Preparing Pressure Washer for USE

Page 5

Snapper 2300 PSI Pressure Washer

IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.

REMOVE PRESSURE

WASHER FROM

CARTON

Remove the parts bag included with pressure washer.

Slice two corners at the end of carton from top to bottom so the panel can be folded down flat, then remove all packing material.

Remove pressure washer from carton.

Carton Contents

Check all contents.

Main unit

Engine Oil

Safety Goggles

High Pressure Hose

Spray Gun

Nozzle Extension

Parts Bag (which includes the following):

Owner’s Manual

Engine Manual

Owner’s Registration Card

Maintenance Kit

Handle Fastening Hardware Kit (which includes):

Carriage Bolts (2)

Plastic Knobs (2)

“L” Hooks (2)

Lock Nuts (2)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-317-7833. If calling for assistance, please have the model, revision, and serial number from the data tag available.

To prepare your pressure washer for operation, you will need to perform these tasks:

Fill out and send in registration card.

Add oil to the engine crankcase.

Add fuel to the fuel tank.

Connect the high pressure hose to the spray gun and the pump.

Connect the water supply to the pump.

Attach nozzle extension to spray gun.

Attach Handle

1.Place the handle assembly onto the handle supports connected to the main unit. Make sure the holes in the handle align with the holes on the handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert the carriage bolts through the holes from the outside of the unit and attach a plastic knob from the inside of the unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

3.Insert one of the “L” hooks through the hole just under the billboard on the left side of the handle (viewing from rear of unit). Hold the hook in place with a pliers and attach the locknut with a

7/16” wrench (Figure 3).

5

Image 5
Contents 2300PSI Equipment Description Table of ContentsSafety Rules High pressure spray may damage fragile items including glass Water Inlet Connection for garden hose Know Your Pressure WasherRemove Pressure Washer from Carton Carton ContentsPreparing Pressure Washer for USE Attach HandleAdd Engine Oil Add FuelConnect Hose and Water Supply to Pump Spray Gun Hook Hose HookConnect High Pressure Hose to Pump Checklist Before Starting EngineHow to Start Your Pressure Washer HOW to USE Your Pressure WasherHow to Stop Your Pressure Washer Safety LatchApplying Detergent with the Adjustable Nozzle How to Use the Adjustable NozzleDo not get closer than 6 inches when cleaning tires Important Use soaps designed specifically forFor Rinsing Pressure Washer RinsingAutomatic Cool Down System Pressure Washer Maintenance SpecificationsGeneral Maintenance Recommendations To remove contaminants from the pump, follow these steps Check In-Line Filter Cleaning Detergent Siphoning TubeNozzle Maintenance Pump Maintenance Engine MaintenanceRing Maintenance Protecting the Pump Preparing the Unit for StorageStoring the Engine Troubleshooting Items Not Illustrated Description Exploded View and Parts List Main UnitDescription Include all parts shown within the box Exploded View and Parts List PumpSnapper 2300 PSI Pressure Washer Snapper 2300 PSI Pressure Washer About your equipment warranty Snapper Owner Warranty Policy Effective January 1Equipment Consumer Use Commercial Use Pressure Washer