Snapper 1807-0 owner manual Checklist Before Starting Engine, Connect High Pressure Hose to Pump

Page 7

Snapper 2300 PSI Pressure Washer

Attach the other end of the high pressure hose to the high pressure outlet on the pump (Figure 4).Tighten by hand.

Figure 4 — Connect High Pressure Hose to Pump

Before you connect your garden hose to the water inlet, inspect the inlet screen (Figure 5). Clean the screen if it contains debris or have it replaced if damaged. DO NOT RUN THE PRESSURE WASHER IF THE SCREEN IS DAMAGED.

Figure 5 — Connect the Garden Hose to Water Inlet

Inspect inlet

screen, DO NOT use if damaged;

clean if dirty.

Run water through your garden hose for 30 seconds to clean out any debris.

IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).

Connect the garden hose (not to exceed 50 feet in length) to the water inlet.Tighten by hand (Figure 5).

CAUTION! There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’ shut-off connector or other convenience-type water shut-off valve. Damage to pressure washer resulting from disregarding this warning will not be covered by the warranty.

Turn ON the water and squeeze the trigger on the gun to purge the pump system of air and impurities.

CAUTION! Before starting the pressure washer, be sure you are wearing adequate eye protection.

CHECKLIST BEFORE STARTING ENGINE

Review the unit’s assembly to ensure you have performed all of the following.

Make sure the handle is in place and secure.

Check that oil has been added to the proper level in the engine crankcase.

Add the proper fuel to fuel tank.

Check for properly tightened hose connections (high pressure and water supply) and that there are no kinks, cuts, or damage to the high pressure hose.

Provide a proper water supply at an adequate flow.

Be sure to read "Safety Rules" and "How To Use Your Pressure Washer" before using the pressure washer.

7

Image 7
Contents 2300PSI Safety Rules Table of ContentsEquipment Description High pressure spray may damage fragile items including glass Water Inlet Connection for garden hose Know Your Pressure WasherAttach Handle Carton ContentsRemove Pressure Washer from Carton Preparing Pressure Washer for USESpray Gun Hook Hose Hook Add FuelAdd Engine Oil Connect Hose and Water Supply to PumpConnect High Pressure Hose to Pump Checklist Before Starting EngineSafety Latch HOW to USE Your Pressure WasherHow to Start Your Pressure Washer How to Stop Your Pressure WasherImportant Use soaps designed specifically for How to Use the Adjustable NozzleApplying Detergent with the Adjustable Nozzle Do not get closer than 6 inches when cleaning tiresAutomatic Cool Down System Pressure Washer RinsingFor Rinsing General Maintenance Recommendations SpecificationsPressure Washer Maintenance Nozzle Maintenance Check In-Line Filter Cleaning Detergent Siphoning TubeTo remove contaminants from the pump, follow these steps Ring Maintenance Engine MaintenancePump Maintenance Storing the Engine Preparing the Unit for StorageProtecting the Pump Troubleshooting Description Exploded View and Parts List Main UnitItems Not Illustrated Description Include all parts shown within the box Exploded View and Parts List PumpSnapper 2300 PSI Pressure Washer Snapper 2300 PSI Pressure Washer Pressure Washer Snapper Owner Warranty Policy Effective January 1About your equipment warranty Equipment Consumer Use Commercial Use