Snapper E55140BV Initial Assembly, Install Chipper Cone All Models, Install the Hopper All Models

Page 21

Initial Assembly

D

A

C

B

Figure 18. Installing the Chipper Cone

A.1/4-20 x 3/4 Screw, Washer, & Nut

B.5/16-18 Flange Nut

C.Cone Base

D.Chipper Cone

Initial Assembly

Install Chipper Cone - All Models

1.Secure the chipper cone (D, Figure 18) to the chipper cone base (C) using 1/4-20 x 3/4 screws, washers, and nuts (A).

2.Position the chipper cone base (C) over the three 5/16-18 threaded studs protruding from the engine plate, and attach using three 5/16-18 flange nuts (B).

3.Tighten the flange nuts securely.

Install the Hopper - All Models

Figure 19. Attaching the Hopper

Figure 20. Installing Hardware Inside the Hopper

1.Attach the hopper to the rotor housing. Make sure to engage the metal lip of the hopper liner inside the housing.

2.Secure the hopper to the rotor housing using two 5/16 x 1/2 hex head bolts and two 5/16 flat washers (Figure 19). Do not tighten hardware at this time.

3.See Figure 20. From the inside of the hopper install one 5/16-18 x 3/4 hex head bolt, 5/16 lockwasher, and 5/16 flat washer into each of the upper and lower holes of the metal hopper liner. Finger tighten only at this time.

4.Check that the hopper is seated correctly and tighten all hardware.

20

Image 21

Contents Mfg. No Description SeriesMfg. No. Description Manual NoTable of Contents Safety Rules & Information Operating Safety Moving Parts Safety Rules and InformationPreparation Safety Rules & InformationSafe Handling of Gasoline Transporting and StorageSafety Decals Safety DecalsDecal Danger, Rotating Cutting Blades Safety Icons Safety IconsMachine CE Specifications Identification NumbersCE Identification Tag Markings Control Functions Features ControlsOperation General Operating SafetyAdding Fuel Starting the EngineStopping the Engine OperationProcessing Materials Chipping TipsChipping & Shredding Recommendations StorageOperation Type of Waste Size Limitations Permitted Maintenance Schedule & Procedures Regular MaintenanceCheck Safety Labels Check for Loose HardwareClean Debris from Engine & Chipper Regular MaintenanceService Interval Before each use and every 100 hours Service Interval Every 25 Hours, or As NecessaryService Interval Every 25 Hours Check / Change Engine Air CleanerInspect Chipping Knives Replace Spark PlugService Interval Every 50 Hours Service Interval Before Each UseEngine Oil Type & Capacity Check Engine Oil LevelTroubleshooting Chart Troubleshooting RepairTroubleshooting & Repair Shredding Hammer Rotation ReplacementRepair Installing the Chipper Cone Chipping Knives Sharpening and ReplacementInitial Assembly Install Chipper Cone All ModelsInstall the Hopper All Models Install the Handle All Models Initial AssemblyInstall Discharge Bag Add Engine OilAdd Fuel Specifications HP* Briggs & Stratton All ModelsHP* Briggs & Stratton Maintenance Items Replacement PartsOptional Accessories Technical Manuals