Install Angling Control Rod

NOTE: If installing the dozer attachment on a unit equipped with a snowcab, replace the control rod sup- port (A, Figure 13) with the hanging support (Ref. No. 19, Figure 8). Mount the hanging support to the front cab cross-bar.

1.Set the angling control support (A, Figure 13) against the right side of the frame. Insert two 5/16-18 x 1-1/2 capscrews (C) through the support (A), and frame.

Space the lower hole away from the frame with a 5/16 washer (D). Secure using flange locknuts (E).

2.Install the eyebolt (B) in the support (A) and secure with a centerlock nut.

Initial Setup & Assembly

3.Connect the lower angling rod (F, Figure 14) to the dozer release lever using a hair pin clip and washer

(G).

4.Insert the upper control rod (C) through the eyelet (B), and secure the eyelet to the support using a 1/4- 20 centerlock nut (A).

NOTE: It may be necessary to leave the eyebolt nut (A, Figure 14) loose to prevent binding.

5.Secure the upper rod (C) to the lower rod (F) using two 5/16-18 x 1-1/4 capscrews (D), washers (qty. 4), lockwashers, and nuts (E). NOTE: Match offset to offset so the rods form a straight line.

Figure 13. Control Rod Support

A.	Angling Support	D. 5/16 Flatwasher
B.	Eyebolt & Locknut	E. Flange Locknuts

C. 5/16-18 x 1-1/2 Capscrews

D	C	B
		B
		E
F
		A
	G

Snapper 1721303-01 manual Install Angling Control Rod