p r e l i m i n a r y
CL 1600 • CL 1200 • CL 800
Compact Linear Precision Power Amplifiers
The new CL Series amplifiers combine outstanding audio performance with maximum reliability and operating safety, as well as being noticeably lighter than equivalent power amplifiers.
As is tradition with the Dynacord amplifier heritage, a large amount of headroom above the spe- cified nominal output has been achieved through the use of optimized power supplies with low dispersion torroidal transformers and class H technology (CL 800 class AB). Considerable weight reduction and energy conservation due to less heat dissipation are also a few of the advantages to the new CL Series.
As expected from a Dynacord design, the CL Series ampli- fiers can handle the toughest on the road abuse. Dynacord’s protection package in every amplifier is matched by no other manufacturer, and the CL Series is no exception. They are reliably protected for thermal capacity, output overload and short cicuit, as well as high frequency osciliation and DC vol- tage in the output stage. A ´soft start´ relay circuit is employ- ed to prevent annoying ´pops´ at start up and an additional circuit is used to limit current draw at start up, protecting bre- akers and fuses.
Dynacord amplifiers constantly monitor input- vs output- signal by means of superfast audio proces- sors which send
Thermal stability is provided by a
connector and the Bridged Mode switch.
Highly precise, yet rugged potentiometers are recessed in the
front panel to prevent physical damage and offer level control scaled in single decibel increments. The clearly laid out LED display shows the operating conditions of the power amplifiers by means of Power, Protect, Signal and Limit indicators.
The electronically balanced XLR input and output connectors are designed for direct operation with professional mixing consoles and signal processors. The complete CL Series power amplifier are desi- gned for
All CL power amplifiers can normally be operated with loads as low as 2 ohms and in bridged mode down to a minimum of 4 ohms with complete operational security.
For rackmount of the CL Series amplifiers there are differnt long