I. Protective screen
Protects the rain gauge funnel from debris
REMOTE SENSOR
FEATURES
•Remote temperature transmission to the main unit via 433 MHz signal
•100 feet (30 meters) transmission range without interference
•LCD display of measured temperature
•Three transmission (3) channels selection
•Selection of the temperature display in Celsius or Fahrenheit
•Case can be wall mounted using
A. LED INDICATOR
•Flashes once when the remote temperature sensor transmits a reading to the main unit.
•Flashes twice when battery power is low.
B. BATTERY COMPARTMENT
11
Holds two
C. RESET
Resets all readings
D. CHANNEL SWITCH
Selects the desired channel
E. WALL-MOUNT RECESSED OPENING
Keeps the remote temperature sensor on the wall
F. °C/ °F SELECTOR
Selects the temperature display in Celsius or Fahrenheit
BEFORE YOU BEGIN
•We recommend using alkaline batteries for the remote rain gauge, temperature sensor and main unit when temperatures are above 32°F (0°C). We recommend using lithium batteries for the temperature sensor when temperatures are below 32°F (0°C).
•Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements).
•ALWAYS install batteries in the remote rain gauge and the remote temperature sensor before the main unit.
•Insert batteries before first use, matching the polarity in the battery compartment
•Press RESET in the remote temperature sensor after each battery change with a paper clip or similar tool.
•Remove protective plastic screen from LCD display (If any)
•During an initial setup, place the main unit close to the remote rain gauge and remote temperature sensor
•Important: Only after reception is established (the remote rainfall data and temperature will appear on the main unit’s display), you may position and mount the remote sensors (the rain gauge and
1112