Acu-Rite 875 instruction manual Calibration Calibrate the Rain Gauge, Tips

Page 11

Calibration

Calibrate the Rain Gauge

The rain gauge can be calibrated to improve accuracy.

Items Needed: rain collector, display unit, plastic cup, pin, screw driver

1.First, place the rain collector on a level surface.

2.Place the display unit close by so you can monitor it during calibration.

3.Make a pin hole in the bottom of a plastic cup. Hold the cup over the rain gauge and fill it with exactly 1 cup (8 oz.) of water, allowing the water to slowly drip into the rain gauge. You should hear the internal cups tipping and see the water drain through the rain gauge.

4.A few seconds after each cup tip, the display unit will display rainfall in approximately 0.01” (0.2 mm) or more increments.

5.The cup of water should take more than 20 minutes to empty; a quicker period will result in an inaccurate calibration. Try to simulate a normal steady rainfall. When the cup is empty of water, the display unit should register 2.20” (55.9 mm).

Tips

There should be nearly an equal number of water drops between cup tips. If not, then adjust the calibration screws beneath the tipping lever until an equal number of water drops are tipping the cups. Then, restart the calibration procedure.

If you don’t hear the cups tipping and see water dripping alternately out of each drain, there may be an issue with the rain gauge or it’s adjustment.

Adjustment

If the rain gauge doesn’t register close to 2.20” (55.9 mm) after the cup is empty, make an EQUAL adjustment to the two calibration screws, located beneath the tipping cups. Turn screws clockwise to increase rainfall; turn screw counter clockwise to decrease rainfall.

To adjust the rainfall reading by 2% turn both screws 1/4 of a turn.

To adjust the rainfall reading by 4% turn both screws 1/2 of a turn.

To adjust the rainfall reading by 8% turn both screws 1 full turn.

COLLECTING CUP

2 CALIBRATION SCREWS

11

Image 11
Contents Rain Gauge Unpacking Instructions Package ContentsDisplay Unit Features & BenefitsRain Collector Rain Collector Install or Replace BatteriesSet the Time, Date & Units Placement for Maximum AccuracyDisplay Unit Placement Important Placement GuidelinesSetup is Complete Rain Collector InstallationWeek Mode Using the Rain Gauge Modes & Historical DataEvent Mode DAY ModeRain Alarm Alarms Flood Watch AlarmNo rainfall TroubleshootingTips Calibration Calibrate the Rain GaugeFCC Information Care & MaintenanceSpecifications 877 221-1252 info@chaney-inst.com Customer SupportPage Page It’s more than accurate, it’s