Install or Replace Batteries, Rain Collector

SETUP

Install or Replace Batteries

AcuRite recommends high quality alkaline batteries for the best product performance. Heavy duty or rechargeable batteries are not recommended.

	SQUEEZEEZE
	LARGE
	LARGETABS
	TABS
1	2	3
		SQUEEZELARGE
		LARGE
	SQUEEZE	TABS

TABS

Rain Collector

1.Separate rain collector cover from the base by gently squeezing tabs and pulling the cover upwards.

2.Remove battery box by squeezing the two tabs on each end together.

3.Remove and discard foam rain gauge stabilizer.

4.Insert 2 x AA batteries into the battery compartment as shown. Follow the polarity (+/-) diagram in the battery compartment.

5.Securely place the battery box back into the rain col- lector base.

6.Securely re-attach the rain collector cover onto rain collector base.

Display Unit

1. Slide off the battery compartment cover.

2. Insert 2 x AA batteries into the battery compartment, as shown. Follow the polarity (+/-) diagram in the battery compartment.

3. Replace the battery cover.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.