Cub Cadet SLT1550, SLT1554 manual Air Filter, Precleaner, Service Paper Element, Spark Plugs

Page 21

•Slowly pour oil into the fill tube. Fill the crankcase until the oil level reaches the full (F) mark on the dipstick (Refer to Page 19).

•Reinstall the oil fill cap/dipstick securely into the oil fill tube.

IMPORTANT: The oil fill cap/dipstick must be installed securely onto the tube at all times when the engine is operating. Severe engine damage could result from a failure to do so.

•Start the tractor engine and allow it to run for thirty seconds, then stop the engine and remove the ignition key.

•Check the oil level and add oil if necessary. Do not overfill the engine crankcase.

•Examine the area around the base of the oil fill tube, the oil filter adapter, and the oil drain valve for leaks before operating the tractor.

IMPORTANT: If leaks are present, have your engine serviced by your Cub Cadet dealer before operating the tractor.

Air Filter

The engine is equipped with a replaceable, high density paper air cleaner element and an oiled, foam precleaner. Always examine the air cleaner before starting the engine. Check for a buildup of dirt and debris around the air cleaner system. Keep this area clean. Also check for loose or damaged components. Replace all bent or damaged air cleaner components.

NOTE: Starting the tractor with loose or damaged air cleaner components could allow unfiltered air into the engine causing premature wear and failure.

Precleaner

Wash and re-oil the precleaner every 25 hours of operation if equipped, (more often under extremely dusty or dirty conditions).

•Loosen the air cleaner cover knob and remove the cover.

•Remove the precleaner.

•Wash the precleaner in warm water with detergent. Rinse the precleaner thoroughly until all traces of detergent are eliminated. Squeeze out excess water (do not wring). Allow the precleaner to air dry.

•Saturate the precleaner with new engine oil. Squeeze out all excess oil.

•Reinstall the precleaner over the paper element.

•Reinstall the air cleaner cover.

Service Paper Element

The paper element should be replaced at least every 100 hours of operation. Replace more frequently if the tractor is operated under extremely dusty conditions. To replace the paper element, proceed as follows:

•Pivot the air cleaner cover upward and unhook the wire latch which secures the element in place.

•Remove the air cleaner element with precleaner. Remove the precleaner from the element and service as instructed earlier in this section.

IMPORTANT: Do not wash the paper element or use pressurized air, as this will damage the element.

Examine the element and discard if dirt and/or damage is present.

NOTE: Handle new elements carefully; do not use if the sealing surfaces are bent or damaged.

•If any loose dirt or debris fell on the air cleaner base when the element was removed, carefully remove it and wipe the base clean. Be careful that none of it drops into the intake.

•Check the air cleaner base. Make sure it is secured and not damaged. Also check the air cleaner cover for damage or improper fit. Replace all damaged air cleaner components.

•Install the precleaner over the new paper element and reinstall the element.

•Lower the wire latch to secure the element in place and pivot the air cleaner cover downward.

Spark Plugs

Every 200 hours of operation, remove the spark plugs, check condition, and reset the gap or replace with a new plugs as necessary.

•Lift the tractor’s hood and locate the spark plug wire on the front, right area of the engine.

•Carefully pull the spark plug wire boot off of the spark plug.

•Before removing the spark plug, clean the area around the base of the plug to keep dirt and debris out of the engine.

•Using a ratchet with a 5/8-inch spark plug socket, remove the spark plug and check its condition.

•Replace the plug if worn, dirty or damaged. Reuse only after resetting the gap as instructed.

NOTE: Do not clean the spark plug in a machine using abrasive grit. Some grit could remain in the spark plug and enter the engine causing extensive wear and damage.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Operator’s Manual Table of Contents General Operation Important Safe Operation PracticesSlope Operation Towing Page — Slope GaugeGas and Oil Fill-up Shipping Brace RemovalAttaching The Steering Wheel Know Your Lawn Tractor Seat Adjustment Lever Ignition Switch ModuleChoke Control Brake PedalElectric PTO Blade Engage Knob Cruise Control LeverParking Brake Lever Safety Interlock Switches Reverse Caution ModeOperating Your Lawn Tractor Setting the Gauge Wheels Starting the EngineStopping the Engine Engaging the Parking Brake Setting The Cruise ControlDriving The Tractor Driving On SlopesOperating the Headlights Using the Deck Lift LeverMoving The Tractor Manually Engaging the PTOMowing Leveling the Deck Front To RearSide to Side Parking Brake Adjustment Steering AdjustmentSeat Adjustment Engine Maintaining Your Lawn TractorEngine Oil Checking the Oil LevelDraining the Oil Changing the Engine OilChanging the Oil Filter Re-filling the Crankcase with OilService Paper Element PrecleanerAir Filter Spark PlugsCleaning the Engine And Deck Fuel FilterSmart Jet Carburetor LubricationAdjustment Tires ServiceFuse Cutting BladesCutting Deck Removal BatteryChanging The Transmission Drive Belt Jump StartingChanging the Deck Belt Hydrostatic TransmissionSLT1550 OFF-SEASON Storage Maintenance Chart Maintenance LOG Trouble Possible Causes Corrective Action TroubleshootingAttachments Attachments & AccessoriesSLT1050 SLT1554 Replacement PartsSLT1550 SLT1554 Capacities SpecificationsPage MANUFACTURER’S Warranty Coverage MANUFACTURER’S Warranty Coverage U.S.A CUB Cadet LLC, P.O. BOX 361131 CLEVELAND, Ohio

SLT1550, SLT1554, SLT1554, SLT1550 specifications

The Cub Cadet SLT1550 and SLT1554 are two impressive lawn tractors known for their powerful performance, innovative technologies, and robust design. Both models are tailored for homeowners who demand efficiency and reliability in maintaining their yards.

The SLT1550 is equipped with a reliable 50-inch cutting deck, while the SLT1554 features a slightly larger 54-inch deck, providing greater coverage for larger lawns. These cutting decks are designed for an even and clean cut, enhancing the overall appearance of your lawn. The decks are also constructed with durable materials that ensure long-lasting performance, resisting wear and tear even under heavy use.

One of the standout features of both models is the powerful engine. The SLT1550 is powered by a reliable Kohler engine, offering 23 horsepower, while the SLT1554 is equipped with a similar-grade engine. This powerful drive enables both tractors to tackle tough terrain and thick grass with ease, significantly reducing mowing time and effort.

Another significant aspect of these lawn tractors is their Hydrostatic transmission. This technology allows for smooth, automatic shifting without the need for manual gear changes, providing an intuitive driving experience. Users can easily adjust their speed while maintaining control over the tractor, making it ideal for both novice and experienced users.

Comfort and ergonomics are key considerations in the design of the SLT1550 and SLT1554. Both models feature an adjustable high-back seat, ensuring that operators can find the optimal position for their comfort during extended mowing periods. Additionally, the tractors are equipped with a user-friendly dashboard that includes essential indicators such as fuel level and engine temperature, allowing for easy monitoring while mowing.

For versatility, both models support various attachments, such as baggers, mulchers, and snow removal equipment, making them suitable for year-round use. The ability to adapt the tractor for different seasons adds significant value for homeowners who want a multi-functional machine.

Safety is also a priority, as both models come with essential safety features, including a terrain-gripping tire design, which enhances stability during operation on uneven surfaces. The tractors also incorporate a seat switch that ensures the engine shuts off if the operator leaves the seat while the mower is engaged.

In summary, the Cub Cadet SLT1550 and SLT1554 deliver a harmonious blend of power, comfort, and versatility, making them excellent choices for homeowners looking to maintain their lawns with ease and efficiency.
Top Page Image Contents