Cub Cadet S7237 service manual Related to Fuel, Related to Batteries, When Mowing

Page 5

B.Related to Fuel

1.Fuel is highly flammable and its vapors can explode if ignited. Please respect it.

2.Do not smoke or permit others to smoke while han- dling fuel.

3.Always use approved containers for fuel and fill slowly to decrease the chance of static electricity buildup and spillage.

4.Store fuel in well ventilated and unoccupied build- ings away from sparks and flames.

5.When dispensing gasoline into approved containers, place the container on the ground when refueling to avoid a possible static electricity ignition of fuel vapors.

6.Do not fill containers while it is inside a vehicle, trunk, the bed of a pickup or floor of a trailer.

7.Always shut off the engine and permit it to cool before removing the fuel tank cap.

8.Always fill the fuel tank outdoors away from sparks and flames.

9.If the fuel container spout will not fit inside the fuel tank opening, use a funnel.

10.When filling the fuel tank, stop when the fuel reaches one inch from the top. This space is necessary for fuel expansion. Do not overfill.

11.Wipe up any spilled fuel.

12. Do not use gasoline fuel classified above E-10 (I.E., E-15 through E-85) as it could cause severe damage to the engine and fuel system.

C. Related to Batteries

Batteries are stored electrical energy devices that may be ser- viceable with removable caps (the electrolyte levels can be checked), or may be non-serviceable (no attempt should be made to open the vents).

Batteries may contain lead (Pb) and sulfuric acid, and they must be re-cycled and not disposed of nor abandoned. Sulfu- ric acid can cause severe burns, and in the event of contact, the areas should be flushed with water and a physician con- tacted. Battery cases should not be punctured. Lead is poi- sonous and is contained within the positive and negative terminals as well as within the battery’s internal grid-work of plates and active materials.

Explosive gases are generated when batteries are re-charged, so sparks, flames and heat sources should be avoided. Loose connections at the battery terminals can produce sprks and heat...connections to the terminals must be kept tight, and the terminals and battery surfaces kept clean of acids and corro- sion. If batteries are re-charged or “jumped” from external sources, make sure that the connections are made properly and in the correct sequence...connect to the positive terminal of the good battery first, then connect that to the positive ter- minal of the weak battery. The third connection should be to the negative terminal of the good battery, followed by the negative terminal of the weak battery. If sparks are observed or heating of the wiring or connectors is detected, disconnect

in reverse order (I.E., the negative terminal of the weak bat- tery first). Batteries should be re-charged at a constant volt- age...generally 14.5 +/- 0.5 volts DC for a nominal 12 volt DC battery.

D.When Mowing

1.Keep adults, children and pets away from the area to be mowed.

2.When operating this mower in the forward direction, do not allow the speed control pedals to rapidly return to Neutral. Always operate the pedals smoothly and avoid any sudden movements when starting or stopping.

3.If the mower is equipped for side discharge, never use the mower without the discharge chute installed and placed in the down position.

4.Always remove debris and other objects from the area to be mowed.(Note: debris and loose grass will reduce traction.)

5.Mow only in daylight.

6.Watch for holes, sprinkler heads and other hidden hazards.

7.Avoid driving too close to trees, creeks, ditches, sand traps and other obstacles.

8.Before backing up, check behind you and watch where you’re going.

9.Always reduce speed when making a turn, and when grass is wet.

10.Always mow laterally or diagonally across slopes, never up and down the slope. Do not operate on steep (greater than 20 degrees, 36%) slopes and slow down before turning.

11.Be careful when crossing gravel paths or roadways. Always turn off the blade clutch switch and wait until the blades stop rotating and raise the cutting deck to the transport position. Always allow other vehicles to have the right-of-way.

12.If you hit a solid object while mowing, turn off the blade clutch switch, place the speed control pedal in the neutral position, move the throttle to slow, set the parking brake, shut off the engine and take the key from the ignition switch. Inspect for damage. Repair any damage. Make sure the blades are in good condi- tion and that the blade bolts are tight before restarting the engine.

13.Never leave the mower unattended without: turning off the blade clutch switch; placing the speed control pedals in the neutral position; moving the throttle to slow; setting the parking brake; shutting off the engine and taking the key from the ignition switch.

14.Never walk or stand on the discharge side of a mower with the engine running. Turn off the blade clutch

5

Image 5
Contents Commercial Zero-Turn Riding Mower Table of Contents Foreword General General Safety OperationsSafety Precautions Related to Batteries When MowingRelated to Fuel Suspension Seat TowingOperator Protection System -Foldable Steering Control Shield Missing Do not Operate Safety Decals and LabelsSpecifications Operating Instructions When MowingSafety Awareness when Mowing To Mow Grass and Produce a Striped Pattern Check the fluid levels and tires Initial AdjustmentsZero Turn Break-In And Operating Proce- dures Lubricate all fittings listed in the maintenance sec- tionOrientation Initial OperationStart the Engine Parking the Mower Mower Cutting BladesMower Deck Maintenance ServiceRemoving the Mower Deck Changing a BladeHydraulic Oil Installing the Battery Battery RemovalElectrical Circuit Specific Gravity Freezing Temp FInflation Pressure TiresBypass Valve Left Side Pump BrakesHydraulic Oil Tank and Filter ScrewStorage To Put the Mower Back in ServiceMaintenance Schedule If Mower is so equipped OIL ChartDeck Corner Ball Wheel Roller Settings Engine RPM Check and AdjustmentDeck Center Anti-Scalp Roller Settings Steering Wheel AdjustmentRemovable Flow Control Baffles Adjustable Front SkirtWiring Diagram Reconfigurable Mower Gaugeslope MANUFACTURER’S Warranty Coverage Warranted Parts Form No Rev -1 02/02/2009