2 - Parts of the tape deck
In the above example, the tape is currently on pro- gram 8, and must move two programs forward before the correct program (i.e. program 10) is reached.
The flashing number on the right of the display should be used as the definitive indication of how many programs will be skipped (if the SKIP keys are pressed too quickly, it is possible that some of the key presses will not be recognized).
When the start of the desired program is reached, the tape deck will enter the play mode if the tape was playing before the skip operation, otherwise it will enter pause mode.
[12] REW and F FWD keys
Use these keys to wind backwards or forwards fast through the tape.
If the tape is stopped or paused, and one of these keys is pressed, << or >> will be shown on the right of the display to indicate the direction of the tape move- ment, if the margin is being displayed (see DISPLAY [23]).
If normal mode has been selected (3.12, "Fast for- ward mode"), pressing either of these keys when the tape is playing will start fast forward or rewind.
If the tape is playing when one of these keys is pressed, and cue mode has been selected (3.12, "Fast forward mode"), the tape enters a “cue” or “review” mode, in which the tape is played forward or back- ward at twice or four times normal speed . The cue/ review speed can be changed by pressing the REW or F FWD key again, and is shown on the display as >>2/>>4 (cue), <<2/<<4 (review).
[13] STOP key
Use this key to stop the transport from whatever mode is currently selected. This includes the “input monitor” mode (see [16] below).
[14] PLAY key
Use this key to start playing when the tape is stopped or paused, or to start recording when the tape is in record pause mode (see below).
The indicator above the key will light when the tape is playing back. In this case, the indicator will be the only transport indicator lit.
The indicator may also be lit in combination with the PAUSE indicator, showing that the unit will enter playback mode almost instantly when the PLAY key is pressed.
If the REC indicator is lit together with the PLAY indicator, the unit is recording.
If the tape is locating as the result of a command to search for the beginning of a program (skip or pro- gram play), and the unit was in play mode before this search operation started, the PLAY indicator will flash, showing that the unit is in “auto play” mode, and playback will restart when the location is reached.
[15] PAUSE key
Use this key to put the tape deck into pause mode, as explained below.
If the tape is stopped or playing, pressing the PAUSE key will put the tape deck into paused play mode (the PLAY and PAUSE indicators will both light).
If the tape deck is in “input monitor” mode (see [16] below), pressing and holding down the RECORD key and pressing the PAUSE key will put the tape deck into record ready mode (the PAUSE and RECORD indicators will both light).
From the record ready mode, pressing the PLAY key will start recording (the PLAY and RECORD indi- cators will both light).
If the tape deck is left in pause mode for some time (three minutes or so), it will drop back into stop mode.
[16] RECORD key
Use this key for recording, as described here.
Press this key once to enter the “input monitor” mode. In this mode, the display gives information about the current status of the tape deck and the con- nections, ensuring that clock signals, digital audio connections, etc. are properly made before recording starts.
If all clock connections are in order, the display will show ANALOG in, AES/EBU or COAXIAL. The peak level meters will show the signal levels received through the selected inputs.
In the case of the latter two digital options, the sam- pling frequency (either 32, 44 or 48) will be shown. If a digital input source is selected, and the sampling frequency of the received signal is outside the allowable range (± 0.1%) the display will show the signal source (AES/EBU or COAXIAL), followed by a question mark. Input monitoring is possible, but recording is not possible.
12 TASCAM