Tascam DA-40 owner manual Important Safety Precautions, Important for U.K. Customers

Page 2

Important Safety Precautions

IMPORTANT (for U.K. Customers)

DO NOT cut off the mains plug from this equipment.

If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid

a possible shock hazard by inadvertent connection to the mains supply.

If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

GREEN-AND-YELLOW : EARTH

BLUE: NEUTRAL

BROWN: LIVE

WARNING: This apparatus must be earthed.

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured GREEN-and-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN-and-YELLOW.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured

BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover.

IF IN DOUBT — CONSULT A COMPETENT ELECTRICIAN.

TO THE USER

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

CAUTION

Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user’s authority to operate this equipment.

For the consumers in Europe

WARNING

This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

Pour les utilisateurs en Europe

AVERTISSEMENT

Il s’agit d’un produit de Classe A. Dans un environnement domestique, cet appareil peut provoquer des interférences radio, dans ce cas l’utilisateur peut être amené à prendre des mesures appropriées.

Für Kunden in Europa

Warnung

Dies is eine Einrichtung, welche die Funk-Entstörung nach Klasse A besitzt. Diese Einrichtung kann im Wohnbereich Funkstörungen versursachen ; in diesem Fall kann vom Betrieber verlang werden, angemessene Maßnahmen durchzuführen und dafür aufzukommen.

2 TASCAM DA-40

Image 2
Contents DA-40 Important Safety Precautions Important for U.K. CustomersImportant Safety Instructions Table of Contents Specifications Introduction to the DA-40 FeaturesInstallation of the tape deck Unpacking and inspectionMaking connections Block Diagram Power connectionsFront and Rear panels Parts of the tape deck Power and displayRecording mode and source switches, etc Tape controls Play key REW and F FWD keysStop key Pause keyData dial REC Mute keyShuttle wheel Margin Reset Command keysCounter Mode CharSkip Play Single PlayRear panel Balanced Analog Outputs Auto ID level Menu functionsDrum time head time Auto ID timeDigital output format Repeat modeRecord mute time Copy prohibit14Initializing settings 10End tally signal12Fast forward mode 15Viewing points at which block errors have occurredMenu functions ID markers START, SKIP, END, Char and renumbering Shift functionsINS/+ and DEL Writing a Start or Skip ID Selecting an ID modeManually writing a Start or Skip ID Erasing an END ID Writing an END IDErasing a Start or Skip ID Erasing titlesLocation memories Setting location memoriesEdit key Locating to location memoriesEntering and editing titles Program modeCharacter editing titling Deleting a title Writing the title to tapeChecking a title Copying and pasting a titleOPEN/CLOSE RC-D45 remote control unit optionID Select PositionREC Mute Remote control transport keysRepeat Specifications SpecificationsAudio specifications Physical specificationsDimensional drawing Error messages Serious error messagesIndex a O Auto IDIndex P SpdifDA-40
Related manuals
Manual 34 pages 40.58 Kb