Cub Cadet 2206 Driving on Slopes, Stopping the Tractor, Operating the Power TAKE-OFF PTO Clutch

Page 17

DRIVING ON SLOPES

Refer to the SLOPE GAUGE on page 57 to help determine slopes where you may not operate safely.

WARNING

Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). The tractor could overturn and cause serious injury.

WARNING

Operate the tractor up and down slopes, never across slopes. Always drive up or down the face of a slope. Do not drive so that the tractor may tip over sideways .

Before operating the tractor on any slope, walk the slope to look for possible hazards such as rocks. mounds, ruts, stumps or other surface irregularities which could cause the tractor to be upset.

Back the tractor with implement up the steepest portion of each slope you intend to work. If the tractor cannot negotiate the slope in reverse, the slope is too steep to be worked.

Avoid turns when driving on a slope. If a turn must be made, turn down the slope. Turning up a slope greatly increases the chance of a roll over.

Avoid stopping when driving up a slope. If it is necessary to stop while driving up a slope, start up smoothly and carefully to reduce the possibility of flipping the tractor over backward.

STOPPING THE TRACTOR

CAUTION

Always engage the brake pedal lock, push the PTO switch to the “OFF” position, lower the equipment and shut off the engine before dismounting. Never try to start the engine while standing on the ground.

Fully depress the brake pedal to bring the tractor to a complete stop (and disengage the cruise control), engage the brake pedal lock, disengage the PTO, turn the ignition switch to “OFF’” and remove the key from the switch before dismounting.

OPERATING THE POWER TAKE-OFF (PTO) CLUTCH

Before operating the new clutch under load (mowing grass, etc.), perform the following break-in procedure:

1.Start and run the engine a few minutes to warm up.

2.With the mowing deck, snow thrower, etc. installed and the engine running at approximately 50% throttle, engage and disengage the clutch at ten second intervals (ten seconds ON-ten seconds OFF) five times. The engine choke may have to be pulled out slightly to accomplish this.

3.Increase the engine speed to 75% throttle and again engage and disengage the PTO clutch at ten second intervals five times.

4.Make certain the PTO is disengaged and stop the engine.

Operate the PTO clutch as follows:

1.Move the throttle control lever to approximately the mid throttle position.

2.Pull the PTO switch to the “RUN” position.

3.Advance the throttle lever to the operating speed (full engine speed).

4.The operator must remain in the tractor seat at all times. If the operator should leave the seat without turning off the power take-off switch, the tractor’s engine will shut off.

5.The PTO clutch cannot be operated when the tractor is driving in the reverse direction. The PTO switch must in the “OFF” position when the reverse control pedal is depressed, or the PTO clutch will automatically disengage. To re-engage the PTO clutch, release the reverse control pedal, move the PTO switch to the “OFF” position, then again pull the switch to the “RUN” position.

DRAWBAR

Drawbar type equipment must be hitched to the tractor only at the hitch hole in the drawbar (See Figure 9).

Figure 9

17

Image 17
Contents OPERATOR’S Manual Important Read Safety Rules and Instructions CarefullyMANUFACTURER’S Warranty Coverage Tractor and Deck Preparation ContentsGeneral Operation Safe Operation PracticesIII. Children II. Slope OperationDo not IV. Service Product Graphics Safety Graphic Located on Left Side of Mower DeckDeflector and Safety Graphic Serial Number Location To the OwnerSafety Interlock Switches Not Shown Section I. Controls and IndicatorsPower TAKE-OFF PTO Control Switch LOW OIL IndicatorIGNITION/LIGHT Switch Hour MeterSeat Adjustment Lever Lift Height IndicatorBrake Pedal Forward Control PedalHood and Side Panels Safety Interlock SwitchesFuel Tank Page Starting the Engine Section II. OperationBefore Operating Your Tractor Cold Weather Starting Tractor BREAK-IN ProcedureStopping the Engine Driving the Tractor Driving on Slopes Operating the Power TAKE-OFF PTO ClutchStopping the Tractor DrawbarAdjusting the Brakes Section III. AdjustmentsAdjusting the Seat Wheel Alignment Front Wheel AdjustmentPivot BAR Adjustment Checking the Transmission Neutral Setting Hydrostatic Neutral AdjustmentFront Control Rod Rear Control Rod Hex Tap Screw Adjusting Lift Assist Spring TensionControl Pivot Sleeve Neutral ArmCarburetor Adjustments Engine Maintenance Section IV. MaintenanceEngine OIL Checking the OIL LevelDraining OIL and Replacing OIL Filter Adding OILFilling the Crankcase Hydrostatic Drive OIL Filter Checking Transmission OIL LevelAdding Transmission OIL Servicing the Precleaner AIR CleanerElement Cover Air Cleaner Base Rubber Grommet Air Cleaner Cover Paper Element Wing NutCleaning Engine Servicing the Paper ElementHeadlights Spark PlugFuel Filter Maintenance of Battery General Battery InformationStorage of the Battery Common Causes for Battery FailureBattery Removal Battery Removal or InstallationBattery Installation Wash Hands after handlingMounting Tires on the RIM TiresTire SizePounds per Square Inch Section V. Mower Deck Installation of DeckQuick Attach ROD Captured Lift ROD Bracket Assembly Idler ARM Lever Stop Bracket PTO Belt Mower Deck Center Double Pulley Front of Deck Removal of Deck Idler ARM Lever Stop Bracket Front Lift ROD Front Roller Bracket Slots Finger guard Blade Hard Level Surface Measure This Distance Side to Side Leveling AdjustmentAdjustment Front to Back Leveling Adjustment Cutting Height Adjustment Lubrication Cleaning and Blade CareMovable Idler Pulley Idler Arm Lever Spindle Drive Belt Spindle Drive Belt ReplacementSection VI. OFF-SEASON Storage Mowing Section VII. MowingOptional Equipment and Accessories Month Season Yearly Storage Maintenance ChartPTO Clutch will not Engage Hard to StartEngine Operates Irregularly or Knocks Lack of Power Trouble ShootingMaintenance NanceLubrication Table Lubrication Guide Lubrication Guide 100 Engine SpecificationsPage Slope Gauge Commercial USE Residential USE CUB Cadet Corporation MANUFACTURER’S Limited WarrantyMaintenance Parts Chart

2206 specifications

The Cub Cadet 2206 is a versatile and robust lawn tractor designed for residential lawn care enthusiasts. It represents the perfect blend of power, precision, and convenience, making it an essential tool for maintaining a pristine landscape.

At the heart of the Cub Cadet 2206 is a reliable Kohler 20 HP engine. This powerful engine provides ample torque and acceleration, enabling users to tackle even the toughest mowing tasks with ease. The engine is built with durability in mind, ensuring long-lasting performance and reduced maintenance concerns.

One of the standout features of this lawn tractor is its 46-inch cutting deck, which allows users to cover large areas quickly while achieving a clean, manicured look. The cutting height is adjustable, providing the flexibility to customize grass length according to personal preferences or lawn care requirements. The deck is designed with a robust structure, ensuring it can withstand regular use while providing consistent results.

The Cub Cadet 2206 employs the innovative Automatic Transmission system that allows for smooth and effortless operation. This user-friendly system provides forward and reverse speeds without the need for manual shifting, making it ideal for navigating around obstacles and maneuvering in tight spaces. The ergonomic steering wheel and comfortable seat enhance the overall driving experience, reducing fatigue during extended mowing sessions.

When it comes to versatility, the Cub Cadet 2206 excels with its optional attachments. Gardeners can equip the tractor with various accessories such as baggers for grass clippings, snow blades for winter snow removal, and spreaders for fertilizing, making it an all-season asset. This adaptability ensures that homeowners can rely on their Cub Cadet throughout the year.

The machine also features a sturdy frame and high-traction tires, ensuring stability and grip on various terrains. This reliability is critical for maintaining control and safety while operating the tractor on sloped or uneven ground.

Additionally, the Cub Cadet 2206 is designed with user-friendly maintenance features. The easy-access oil filter and spacious engine compartment make routine upkeep significantly more manageable, contributing to the tractor's longevity and performance.

In summary, the Cub Cadet 2206 is an exceptional lawn tractor that combines power, comfort, and versatility. Whether you're mowing a small yard or a larger landscape, this machine's advanced features and user-centric design make lawn care a straightforward and enjoyable task. With proper maintenance and care, the Cub Cadet 2206 can be a reliable partner in keeping your outdoor space looking its best for years to come.