Cub Cadet 19HP Enforcer 44, 21HP Enforcer 48, 23HP Enforcer 54 Hydrostatic Drive System

Page 19

Spindle

Figure 8

5.Changing the Spindle Assembly

a.Jack up the front of the mowing deck about one foot and block it in that position.

b.Make sure the blade clutch is disengaged.

c.Remove the deck cover.

d.Remove the drive belts. (See 4. Changing Blade Drive Belts.)

e.Remove the cutter blade. (See 2. Chang- ing a Blade.)

f.Using a wrench or socket ratchet remove four hex nuts, and the four hex head cap screws. Remove the spindle assembly.

g.Reverse the process to install the spindle assembly.

C.Hydrostatic Drive System

1.Your zero turn riding mower is equipped with dual integrated hydrostatic pumps, motors, and gear reduction transaxles that are sealed and do not require service, maintenance, or adjust- ments. The fluid level in the expansion tank must be maintained at 1/2” to 1” above the bot- tom of the tank.

Hydrostatic

Transaxles

Figure 9

D.Electrical Circuit

Danger:

Read General Safety Precautions Nos. 9 and 10.

1.Battery: The battery is located beneath the operator’s seat. If so equipped, remove the fillcaps and check the level of the liquid elec- trolyte in the battery every 50 operating hours. If the level in any of the six cells has dropped below the bottom of the split ring inside the fill hole, refill the cell with distilled water. To keep the outside of the battery clean, brush on a strong solution of bicarbonate of soda and water and rinse with clean water. Keep the contacts and cable ends clean with a wire brush and make sure the connections are tight. Coat the terminals with petroleum jelly to prevent corrosion.

2.Battery Removal

Warning:

When removing the cables from the battery follow these steps to avoid a short between the wrench and the frame.

a.Remove the negative (black) cable.

b.Remove the positive (red) cable.

c.Release the hold down straps.

d.Remove the battery without tipping.

3.Battery Storage: When storing the mower for long periods of time the following guidelines should be performed.

a.Disconnect the battery cables from the ter- minals and remove the battery.

b.Clean the battery before storing. A dirty battery will lose its charge over time.

c.Store the battery with a full charge. A dis- charged battery will freeze (refer to the table below).

Specific Gravity

Freezing Temp (°F)

 

 

1.265

-71

 

 

1.250

-62

 

 

1.200

-16

 

 

1.150

5

 

 

1.100

16

 

 

d.Recharge battery when ever the specific gravity value is less than 1.225

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Foreword Safe Operation Practices General Safety OperationsSlope Operation Related to Batteries ServiceSuspension Seat Related to FuelTowing Assemble Chute Deflector to this Unit Before Operating Safety Decals and LabelsSpecifications Operating Instructions When MowingGeneral To Mow Grass and Produce a Striped Pat- tern Safety Awareness when MowingSteering Levers Check the fluid levels and tires Initial AdjustmentsInitial Operation Zero Turn Break-In And Operating ProceduresLubricate all fittings listed in the mainte- nance section OrientationStart the Engine Parking the Mower Mower Cutting BladesCleaning your Deck Maintenance ServiceSharpening the Blade Mower DeckRemoving the Mower Deck Changing a BladeElectrical Circuit Changing the Spindle AssemblyBattery Removal Hydrostatic Drive SystemJump Starting Installing the BatteryBrakes TiresInflation Pressure Hydraulic System To Put the Mower Back in ServiceStorage Maintenance Schedule If Mower is so equipped OIL ChartEngine RPM Check and Adjustment High Speed Tracking AdjustmentLap Bar Adjustment Deck Corner Ball Wheel Roller SettingsDeck Center Anti-Scalp Roller Deck leveling Procedure Wiring Diagram Gaugeslope Maintenance Record Page U.S.A Canada

19HP Enforcer 44, 21HP Enforcer 48, 23HP Enforcer 54 specifications

The Cub Cadet Enforcer series is a robust line of ride-on lawn mowers designed for superior performance, versatility, and user convenience. Three prominent models in this series include the 19HP Enforcer 44, the 21HP Enforcer 48, and the 23HP Enforcer 54. Each of these mowers showcases a unique set of features tailored to meet various yard care needs.

The 19HP Enforcer 44 is equipped with a powerful 19 horsepower engine, offering reliable performance for smaller to mid-sized lawns. This model features a 44-inch cutting deck, allowing for efficient mowing without compromising fuel efficiency. The mower's hydrostatic transmission provides smooth acceleration and easy maneuverability, making it ideal for navigating around obstacles. Key technologies include Cub Cadet's signature AeroForce cutting system, which enhances grass collection and creates an immaculate finish.

Next, the 21HP Enforcer 48 takes performance a step further. With its 21 horsepower engine, this mower is designed for those who require both power and precision. The 48-inch cutting deck provides a broader swath of grass, enabling homeowners to tackle larger lawns with ease. The Enforcer 48 also incorporates a heavy-duty frame for increased durability and stability. Ergonomically designed controls ensure a comfortable user experience, while the cutting height can be easily adjusted for various lawn conditions.

Lastly, the 23HP Enforcer 54 stands out with its 23 horsepower engine and expansive 54-inch cutting deck, making it ideal for larger properties and commercial mowing tasks. This model is equipped with advanced features such as a reinforced cutting deck and a powerful blade engagement system, ensuring exceptional performance in tough mowing conditions. The Enforcer 54 also benefits from an intuitive dashboard, where users can monitor vital mower parameters and maintain optimal performance with ease.

All three mowers share common characteristics, including a robust design built to withstand the rigors of regular use. They also feature an easy-to-access fuel system and tool-free maintenance points, simplifying upkeep for owners. With their powerful engines, advanced cutting technology, and user-friendly features, the Cub Cadet Enforcer series delivers a reliable solution for all lawn care needs, making it a preferred choice for homeowners and professionals alike.
Top Page Image Contents