Cub Cadet Hydrostatic Zero-Turn Commercial Riding Mower Professional Turf Equipment OIL Chart

Page 25

.

OIL CHART

Apply a few drops of engine oil or use a spray lubricant. Apply the oil to both sides of pivot points. Wipe off any excess. Start engine and operate mower briefly to insure that oil spreads evenly.

Number of Oil Points

Description

DAILY
4	Deck Suspension Pivots
4	Height Adjustment Turnbuckle Clevis Pin
2	Height Adjustment Handle Pivots
2	Height Adjustment Stop Pivots
2	Deck Lift Linkage Pivots
2	Transport Handle Pivots
1	Transport Handle Pin
2	Deck Frame Up-and-Down Pivots

WEEKLY

1Seat Hinge

2Steering Lever Linkage Rod End Bearings

2	Lever Return Assembly Rod End Bearings
2	Pump Control Lever Pivots
1	Brake Lever Pivot Clevis Pin
1	Brake Lever Control Rod Pivot
1	Brake Control Rod Swivel Joint
4	Brake Rod Clevis Pins
2	Brake Shaft Assembly Pivots

2Grass Collection System Lid Hinges

(If Mower is so equipped)

LUBRICATION CHART

Use a grease-gun filled with NO. 2 Multipurpose Lithium Base Grease

No. of Grease Fittings

Description

EVERY 25 HOURS
3	Blade Spindle Bearings
WEEKLY
2	Front Caster Wheels
2	Front Caster Wheel Spindles
4	Mowing Deck Pivots
2	Deck Take-Up Idler Pivots
1	Axle Pivot
2	Steering Lever Pivots
1	Hydro Take-up Idler Pivot
1	Park Brake Pivot
2	Mower Deck Ball Wheels

25

Image 25

Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Models Listed in this Manual ForwardSafety Precautions General Safety OperationsGeneral Related to Fuel When MowingRelated to Batteries Operator Protection System Shield Missing do not Operate Safety Decals and LabelsAir Cleaner Net WeightControls Parking BrakeSafety Awareness when Mowing When MowingOperating Instructions To Mow Grass and Produce a Striped Pat- tern Figure Fuel Shutoff Valve Check the fluid levels and tires Initial AdjustmentsLubricate all fittings listed in the mainte- nance section Zero Turn Break-In And Operating ProceduresOrientation Initial OperationStart the Engine Parking the Mower Mower Cutting BladesMower Deck Maintenance ServiceRemoving the Mower Deck Changing a BladeHydraulic Oil Changing the Spindle AssemblyChanging the Blade Drive Belts Electrical Circuit Stop the engine and remove the key from the ignition switchAdding Hydraulic Oil use SAE14W Draining Hydraulic OilInstalling the Battery Battery RemovalSpecific Gravity Freezing Temp F Jump StartingInflation Pressure TiresBrakes Hydraulic Oil Tank and Filter Storage To Put the Mower Back in ServiceMaintenance Schedule If Mower is so equipped OIL ChartEnginge RPM Check and Adjustment High Speed Tracking AdjustmentDeck Center Anti-Scalp Roller Settings Deck Corner Ball Wheel Roller SettingsLap Bar Adjustment Deck leveling Procedure Wiring Diagram Maintenance Record Page MANUFACTURER’S Limited Warranty Turf Equipment