Gardena Art. 867, Art. 869, Art. 879 / 880, Art. 875 instruction

4.2. Operating Instructions for Pressure Sprayer Art. No. 875 / 879 / 880

Filling the container:

1.	Mix the fluid well.
2.	Press the pump handle P down slightly, turn to the left and
	remove the pump Q.
3.	Pour the fluid into the container up to the maximum mark

(5 litres).

Please observe the safety and proportioning instructions

provided by the manufacturer of the product you are going

to spray.

4. Tighten the pump again with the pump handle P by hand

(do not use pliers).

Risk of injury!

AV Never connect your Pressure Sprayer to an air compressor.

5.Unlock the pump handle P by turning slightly to the left and pump the pump repeatedly (approx. 30 - 40 times) until the operating pressure is reached.

Any excess pressure escapes through the safety valve R.

The Pressure Sprayer Art. No. 879 / 880 features a window with a scale S to help you measure out the appropriate dosage of fertilisers. The window also allows you to see how much fluid is left in the container.

4.3.General Operating Instructions for all Pressure Sprayers (Art. No. 867/869 / 875 / 879 / 880)

Spraying:

Adjusting the spray tube:

1.Press the operating switch T on the handle. The Pressure Sprayer begins spraying.

2.Release the operating switch T on the handle. The Pressure Sprayer stops spraying.

Setting the permanent lock:

vPress the permanent lock U.

The operating switch T is pressed down and stays down.

The spray tube can be swivelled 360° in the hand valve.

1.Unscrew the union nut 1 on the hand valve 2.

2.Turn the spray tube 3 to the correct position.

3.Tighten the union nut 1 on the hand valve 2 by hand (do not use pliers).

Setting the spray jet:

You can adjust the spray jet from full jet (nozzle closed) to a fine mist spray (nozzle open).

vOpen or close the spray nozzle V according to the spray jet you require.