Homelite HP3127S Attaching the Resting Foot, Assembling the Spray Wand, Attaching Injection Hose

ASSEMBLY

ATTACHING THE RESTING FOOT

See Figure 3.

Lift the machine slightly. Slide the resting foot into the bottom of the spray wand storage tube.

Push the resting foot into the storage tube until the base of the machine rests in the grooves on top of the resting foot.

RESTING FOOT

ASSEMBLING THE SPRAY WAND
See Figure 4.	Fig. 3
To attach the assist handle assembly:
 Remove the wing nut from the assist handle assembly
then slide the spray wand assembly onto the assist handle	DETENT
assembly bracket.
NOTE: The smooth side of the assist handle assembly
can be facing down or up.	WING NUT

Position the assist handle between the ribs of the spray

wand aligning the tab and the detent.

 Secure the assist handle in place by tightening the wing nut.

To attach the spray wand extension:
 Place the threaded end of the wand extension in the
connector on the end of the spray wand assembly. Push	TAB
until it snaps into place.
 Turn the connector clockwise until it stops. This secures
the wand extension in place.
 When not in use, place the assembled spray wand into		SPRAY
the spray wand storage.
		WAND
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY		CONNECTOR
See Figure 5.
 Uncoil the high pressure hose.		RIBS
 Pull back and hold the quick-connect collar on the high	ASSIST
pressure hose.
	HANDLE
 Insert the inlet coupler on the spray wand handle into the
	ASSEMBLY	SPRAY
collar.
		WAND
 Release the collar and push until it clicks.
		EXTENSION
 Pull on the hose to be certain it is properly secured.		Fig. 4
ATTACHING INJECTION HOSE
		INLET
See Figure 6.
		COUPLER
Before detergent can be used with this machine, the
	HIGH
injection hose must be attached.
 Uncoil the clear injection hose.	PRESSURE
	HOSE
 Push the open end of the injection hose securely over the
barbed fitting.
 Lift the chemical bucket and push the injection hose into		QUICK-
the slot on the back of the bucket.
		CONNECT
 Replace the bucket in the bucket holder.
		COLLAR
		Fig. 5
Page 10