Check In-Line Filter, Nozzle Maintenance | Generac 1418-0 specification

Generac Portable Products 3,000 PSI High Pressure Washer

Check In-Line Filter

Refer to Figure 13 and service the in-line filter if it becomes clogged, as follows:

Figure 13 — Clean In-Line Filter

Filter Screen

Nozzle Extension

O-ring

1.Detach gun and nozzle extension from high pressure hose. Detach nozzle extension from gun and remove o-ring and screen from nozzle extension. Flush the screen, gun, and adjustable nozzle extension with clean water to clear debris.

2.If the screen is damaged, the o-ring kit contains a replacement in-line filter screen and an o-ring. If undamaged, reuse screen.

3.Place the in-line filter screen into the threaded end of the nozzle extension. Direction does not matter. Push the screen in with the eraser end of a pencil until it rests flat at the bottom of the opening. Take care to not bend the screen.

4.Place the o-ring into the recess. Push the o-ring snugly against the in-line filter screen.

5.Assemble the nozzle extension to the spray gun, as described earlier in this manual.

Purge Pump of Air and

Contaminants

To remove air from the pump, follow these steps:

•Set up the pressure washer as described in “Preparing Pressure Washer For Use” (page 5). Connect the water supply and turn water on.

•Remove the nozzle from the nozzle extension.

•Pull the trigger on the gun and hold.

•When the water supply is steady and constant, engage the safety latch and refasten the nozzle attachment.

To remove contaminants from the pump, follow these steps:

•Set up the pressure washer as described in “Preparing Pressure Washer For Use” (page 5). Connect the water supply and turn water on.

•Remove the nozzle from the nozzle extension.

•Start the engine according to instructions in “How To Use Your Pressure Washer” (page 7).

•Squeeze the trigger on the gun and hold.

•When the water supply is steady and constant, engage the safety latch and refasten the nozzle attachment.

Nozzle Maintenance

If a nozzle becomes restricted or clogged with foreign materials, such as dirt, excessive pump pressure may develop. A pulsing sensation occurs during use. This generally is not a pump related problem, but rather a clogged or partially restricted nozzle.

If a nozzle become clogged or partially restricted, immediately clean it with the kit included with your pressure washer by following these instructions:

•Shut off the engine and turn off the water supply.

•Remove the nozzle from the end of the nozzle extension.

•Use the wire included in the kit or a small paper clip to free the foreign materials clogging or restricting the nozzle (Figure 14).

Figure 14 — Nozzle Maintenance

Use wire here

to remove

debris.

•Remove additional debris by rinsing out the nozzle. Rinse between 30 to 60 seconds.

•Reinstall the nozzle into the nozzle extension.

•Reconnect the water supply, turn on the water, and start the engine.

•Test the pressure washer.