Karcher HDS 1295, HDS 895 S, HDS 695 S, HDS 745, HDS 1195, HDS 995 manual Commissioning

English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295			6
	NOTE ON THE OPERATING INSTRUCTIONS
All of the item numbers described below in the		Figure 3
operating instructions are referenced in the		Only fill with diesel fuel or light fuel oil.
illustration of the unit.
		It is forbidden to use unsuitable fuels,
	COMMISSIONING	e.g. benzine (explosion hazard, damage to
		unit).
		Close tank cap
		Wipe off excess fuel
–	Unit, piping, high-pressure hose and
	connections must be in perfect working order!	Filling with cleaning agent
–	Lock the hand brake.
		* Only use Kärcher products.
Checking oil level
		* Never pour in solvent (petrol, acetone, thinner
Figure 1		etc.)!
		* Avoid contact with eyes and skin
		* Pay attention to cleaning-agent
		manufacturer's instructions on safety and
Contact Kärcher AFTER-SALES SERVICE		handling
immediately if oil is opaque!		Kärcher can provide an individual range of
If oil level is approaching MIN mark, fill up with
oil as far as MAX mark.		cleaning and treatment agents.
Seal oil filler inlet.		Your dealer will be pleased to advise you.
Refer to technical data for oil grade.		Figure 4
Filling with scale inhibitor		Fill with cleaning agent
Figure 2		Mounting handgun
		– Connect steel pipe (item 15) with handgun
(sample pack included with scope of delivery)		(item 20)
		– Insert high-pressure nozzle in union nut
Scale inhibitor stops heating coil becoming		– Mount and tighten unit nut
calcified when using hard tap water. Is is		– Mount the high-pressure hose to the high-
metered in at the inlet in the water reservoir one		pressure connection.(Figure 6)
drop at a time.		Mounting of spare high-pressure hose
The metering is set at the factory to medium-
hard water.		Figure 5
For other water hardness classes, call in
Kärcher AFTER-SALES SERVICE to perform
adjustment to local conditions.
Filling with fuel		Mounting handle
		Figure 7
– Never operate unit with fuel tank empty! Fuel
		Water connection
	pump would otherwise be destroyed!
		For connected loads, refer to Technical Data.
		Install the supply hose to the water inlet
		(item 18) of the unit.
		(supply hose is not part of scope of delivery)