IMPORTANT PRECAUTIONS – continued
Water Supply (Cold Water Only)
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty“
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
4
Step 1 | Step 2 | Step 3 | |
Attach one adapter bracket to | Place detergent tank between | Attach handle onto top of | |
pressure washer by aligning | adapter brackets as shown. | adapter brackets. Press down | |
holes on adapter bracket with | Attach second adapter | to lock. Tighten with screws | |
posts on the pressure washer asbracket. | as shown. | ||
shown. Tighten the two screws. |
| Note: Hose/cord caddy and | |
|
|
| trigger gun holder must be |
|
|
| on opposite sides |
|
|
|
|
|
|
|
|
Step 4
Pull out the locking slide from the right side of the trigger gun handle, and insert the small end of the high pressure hose into place. Push the locking slide back into the trigger gun to lock the hose in position.