5016-001

C Paper jam 202 displays indicating media is detected and fed from tray x and paper jams after it passes the paper pass sensor.

 

FRU

Action

 

 

 

1

Fuser Assembly

Fuser assembly available:

 

Paper Exit Sensor

Try a new fuser assembly before proceeding

 

Flag and Spring

with this service check.

 

Heat Insulating

Fuser assembly not available:

 

Cover 1

If the media jams over the exit sensor, check the

 

 

 

 

exit sensor flag and spring for correct operation

 

 

and loose or broken parts. If a problem is found,

 

 

replace as necessary.

 

 

Check the heat insulating cover 1 for anything

 

 

that would cause a paper jam.

 

 

 

Parallel Port Service Check

Run the “Parallel Wrap Test” on page 3-11.

The Parallel Wrap Test is designed to check the parallel port hardware by using a wrap plug (P/N 1319128) which invokes the Parallel Diagnostic Test. This test helps isolate the printer from the parallel cable and host. The test provides displays failure information for approximately 3 seconds. If the test detects a problem, replace the controller board.

Diagnostic Information 2-71

Page 137
Image 137
Lexmark 5016-001 manual Parallel Port Service Check, Fuser assembly available