5016-001

A The fuser drive system is not operating properly.

 

FRU

Action

 

 

 

1

Fuser Assembly

Check the fuser assembly internal drive gears

 

Fuser Drive Motor

for binding, or broken or worn teeth. If a

 

problem exists, repair or replace the fuser

 

Fuser Motor/Paper

assembly.

 

 

 

 

Feed Motor Carriage

Remove the fuser drive motor from the stay

 

Unit Motor Cable

assembly, leaving the motor cable connected

 

Engine Board

to the motor. Turn the printer on, but do not

 

allow the motor to touch other areas of the

 

 

printer. Verify the motor turns during POR. If it

 

 

does, the problem is most likely in the motor

 

 

mounting stay assembly. Go to step 2.

 

 

Check the motor for shorts between the case

 

 

and each motor winding. If a short is found,

 

 

replace the motor.

 

 

Note: Damage to the engine board may result

 

 

from a shorted motor.

 

 

Check the motor for open windings. If found,

 

 

replace the motor.

 

 

Check continuity of the fuser motor/paper

 

 

feed motor/carriage unit motor cable.

 

 

If incorrect, replace the cable.

 

 

If correct, replace the engine board.

 

 

 

2

Motor Mounting Stay

Check the fuser drive gears, gears C3-1, C3-

 

Assembly

2, the clutch spring, motor drive gear, gear C2

 

(Fuser Drive Parts)

and C4 for signs of chipped gear teeth, worn

 

 

parts, or improper operation. If problems are

 

 

found, repair as necessary.

 

 

Check the cam gears and solenoid for proper

 

 

operation and signs of broken or worn gear

 

 

teeth or damaged parts. If found, repair or

 

 

replace the motor mounting stay assembly.

 

 

 

 

2-54Service Manual

Page 120
Image 120
Lexmark 5016-001 manual Fuser drive system is not operating properly