Lexmark 5016-001 manual Cam turns from approximately 0 V to +5 V dc

5016-001

B The fuser drive system is operating properly and the cam disk is turning.

	FRU	Action
1	Cam Sensor (PH16)	Be sure the cam sensor is mounted correctly
	Engine Board (M4)	and locked into place.
		Check the following voltages on the cam
	SN Cable
		sensor:
		Pin #		Signal	Voltage	Voltage
				Voltage	Disc in	Disc Out
		1 (Orange)		+5 V dc	+5 V dc	+5 V dc
		2 (Brown)		-CCSENS	+5 V dc	0 V dc
		3 (Green)		GND	0 V dc	0 V dc
		Note: The voltage on pin 2 should vary, as the
		cam turns from approximately 0 V to +5 V dc.
		•	If the voltage on Pin 1 is incorrect, check
			the cable. If incorrect, replace the cable.
		•	If the cable is good, replace the following
			FRU's in the order shown:
		1. Cam sensor
		2. Engine board
		3. SN cable

Diagnostic Information 2-55