Lexmark 5016-001 manual Fru

5016-001

A It is difficult to remove tray x from the 250/250 option base assembly.

Note: Do not force tray x from the base unit, as damage to the paper detect sensor lever, or pick up roller bracket assembly may occur. Lift up on the bracket and sensor lever and carefully remove tray x.

	FRU	Action
1	Paper Detect	Check the paper feed frame, paper detect sensor
	Sensor Lever	lever, release lever and pick up spring, for the
	Release Lever	failing tray, for correct installation and operation.
		If incorrect, repair as necessary.
	Pick Up Return
	Spring
	Feed Frame

B You are unable to select the 250/250 tray option. The option is not recognized.

	FRU	Action
1	Option Cable	Be sure cable OP is correctly installed on the
	OP Autoconnect	interconnect board at CN801. Check both the
	Base Printer	option and base OP printer cables for signs of
		damage, especially to the autoconnect connector
	Cable (OP)	pins. Replace either cable, if any problems are
	Autoconnect	found.
2	Interconnect	Replace the following FRUs in the order shown:
	Board	1. Option interconnect board
	Engine Board	2. Engine board

2-110Service Manual