5016-001
Printer Setup
Note: Defaults within this printer can be set to either U.S. or Non- U.S.
Setting the Page Count
This lets the servicer change the page count from the diagnostic menu. This is used whenever the engine board is replaced because this board contains the printer's NVRAM Memory where the page count is stored.
To set the Page Count:
1.Select Page Count from the Diagnostic menu. The current page count displays and the leftmost digit blinks, indicating it is the first digit to be changed.
2.Press either Menu> or <Menu until the desired value displays.
3.Press Select to move to the next digit.
4.Press Menu> or <Menu until the desired value displays. Continue with each digit until you set the page count. You can skip any digit by pressing Select.
5.Press Select to save the new page count in NVRAM.
6.Press Return/Stop to exit the Diagnostic menu.
Viewing the Permanent Page Count
Note: The Permanent Page Count can only be viewed; it cannot be changed.
To view the Permanent Page Count:
1.Select Permanent Page Count from the menu.
2.Press Return/Stop to exit the Diagnostic menu.
Serial Number
The serial number is set at the factory and cannot be changed. This is for viewing the serial number only.
The serial number will be XXXXXXXX (8 digit string)
Where X=A to Z, or 0 to 9.
Diagnostic Aids
