Lexmark 5016-001 manual

5016-001

D 241 Paper Jam - Check Tray 1 displays and media jams over the pass through sensor.

FRU	Action
1 Paper Pass	Check the paper pass sensor flag and spring for
Sensor Flag	correct operation and broken or loose parts. If a
Paper Pass	problem is found, repair as necessary.
	Note: The voltages for the paper pass sensor
Sensor Spring
Paper Pass	can be checked at the 6 pin inline cable
	connector located in the HVPS to engine board
Sensor Board	cable harness above the temperature/humidity
MK 2 Cable	board assembly, on the left side of the printer.
	Voltages on inline connector:
Engine Board
	Pin #		Voltage Static	Voltage Feeding
	3	(Orange)	+5 V dc	+5 V dc
	4	(Blue)	+5 V dc	0 V dc to +5 V dc
	5	(Brown)	+5 V dc	Transparency +5 V dc
	6	(Green)	0 V dc	0 V dc
	Note: All voltages are approximate.

•If the voltage on pin 3 is incorrect, check the continuity of the cable. If incorrect, and if the cable is good, replace the engine board.

•If the voltage on pin 3 is correct, but the voltage on pin 4 is incorrect, replace the following parts in the order shown:

1.Paper pass sensor board assembly 2.Engine board

3.Mk 2 cable

Diagnostic Information 2-103