Resist Sensor Board Removal

1.Remove all covers, refer to the “Cover Removals” on page 4-2.

2.Remove the LVPS assembly, refer to the “LVPS Assembly Removal” on page 4-10.

3.Remove the C-clip and the shaft bearing from the left side of the registration roll.

4.Unlatch the cable cover bracket.

5.Loosen the registration roll from the left side.

6.Remove the two (2) screws from the paper A guide and remove the guide.

7.Remove the two (2) screws from the paper sensor and remove the sensor.

Waste Toner Board Assembly Removal

1.Remove the grid 1 block assembly, refer to the “Grid Block 1 Assembly Removal” on page 4-16.

2.Remove the two (2) screws from the board.

3.Remove the waste toner board assembly.

4-22Service Manual