Grid Block 1 Assembly Removal

1.Remove the left side cover, refer to the “Left Side Cover Removal” on page 4-3.

2.Remove the HVPS assembly, refer to the “HVPS Board Assembly Removal” on page 4-20.

3.Remove the three (3) screws [A] from the block assembly.

4.Remove the block assembly.

5.Disconnect the waste toner sensor board cable.

Note: When replacing the grid 1 block assembly, be sure not to damage or deform the high voltage contact.

4-16Service Manual

Lexmark 5016-001 manual Grid Block 1 Assembly Removal