Jet Tools JWL-1642EVS-2  Warning, Contents of the Shipping Containers, Unpacking and Clean-Up

WARNING

Read and understand the entire contents of this manual before attempting assembly or operation!

Failure to comply may cause serious injury!

Contents of the Shipping Containers

1.Lathe

2.Cast Legs

1. Tailstock

1. Headstock

1. Tool Rest Body

1. Tool Basket

1. Guard Assembly

1. Accessory Package

1.Owner’s Manual & Warranty Card

Accessory Package Box

1.Live Center

1. Rod for Live Center

1. Spur Center

1. Index Pin

1. Face Plate

1. Rod for Face Plate

1. Knockout Rod Headstock

1. Tool Rest

4. Adjustable Feet

Tool Basket Bracket Hardware

2. Hex Sckt Cp Screws 5/16”-18 x 1-1/2”

4. Flat Washers 5/16”

2.Set Screws 1/4”-20 x 1/4”

3.Hex Nuts 5/16”

1. Set Screw 5/16”-18 x 5/8”

Unpacking and Clean-Up

Contents of Accessory Package

1.Remove the shipping container. Do not discard any shipping material until the lathe is set up and running properly.

2.Remove hex cap bolts from skid bottom and move the lathe off the skid and into position.

3.Clean all rust protected surfaces with a cleaner degreaser. Clean thoroughly under the headstock, tailstock and tool rest body.

Assembly

1.Secure tool rest (A, Fig. 1) to tool rest body (B, Fig. 1) by tightening handle (C, Fig. 1).

2.Slide the tailstock and tool rest to the headstock end of the lathe bed. See “Controls and Features” section of this manual on how to move the tailstock and tool rest.

9