Warnings
SPEED RECOMMENDATIONS
| Diameter of Work | Roughing RPM | General Cutting RPM | Finishing RPM |
|
|
|
|
|
|
|
| Under 2" | 1500 | 3000 | 3000 |
|
|
|
|
|
|
|
| 2 to 4" | 600 | 1500 | 2300 |
|
|
|
|
|
|
|
| 4 to 6" | 450 | 1100 | 1500 |
|
|
|
|
|
|
|
| 6 to 8" | 450 | 600 | 1100 |
|
|
|
|
|
|
|
| 8 to 10" | 450 | 600 | 850 |
|
|
|
|
|
|
|
| 10 to 12" | 450 | 600 | 850 |
|
|
|
|
|
|
|
| 12 to 14" | 450 | 450 | 600 |
|
|
|
|
|
|
|
26.When sanding, remove the tool rest from the machine, apply light pressure and use a slow speed to avoid heat build up.
27.When turning large diameter pieces, such as bowls, always operate the lathe at low speeds. See the speed recommendation chart.
28.Do not attempt to engage the spindle lock pin until the spindle has stopped. If leaving the machine area, turn it off and wait until the spindle stops before departing.
29.Make no adjustments except speed changes with the spindle rotating and always disconnect the machine from the power source when performing maintenance to avoid accidental starting or electrical shock.
30.Provide for adequate space surrounding work area and
31.When stopping the lathe, never grab the part or faceplate to slow it down. Let the work coast to a stop.
32.Use only JET factory authorized replacement parts and accessories; otherwise, the warranty and guarantee are null and void.
33.Do not use this JET wood lathe for other than its intended purpose. If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use.
4
