Jet Tools JWL-1642EVS-2 Speed Change, Lathe Tools, Disconnect the machine from the power source

Speed Change

1.Disconnect the machine from the power source!

2.Loosen the locking handle (A, Fig. 11).

3.Lift up on the tensioning handle (B, Fig. 11) to remove tension from the poly v-belt. You can now position the belt in the desired speed range. It is pictured in the low speed pulley range. Note: The “High” speed range (120-3200) provides maximum speed, where as the “Low” speed range (50-1200) will provide maximum torque.

4.Lower the tensioning handle so that the weight of the motor provides the needed tension and tighten the locking handle.

AC Inverter does not require any programming. It is pre-programmed from the factory. The buttons and knob on the face of inverter should not be changed. Use only controls on the front of headstock. Refer to Inverter manual.

Lathe Tools

If possible, select only high quality, high-speed steel turning tools with long handles. As one becomes proficient in turning, a variety of specialty tools for specific applications can be acquired. The following tools provide the basics for most woodturning projects. See your JET distributor for a wide variety of JET woodturning tools.

Roughing Gouge — used for rapidly cutting raw wood into round stock, see Figure 12.

Deep Fluted Bowl Gouge — used for turning bowls and plates, see Figure 12.

Spindle Gouge — used for turning beads, coves and other details, see Figure 12.

Spear — fine scraping and delicate operations, such as the forming of beads, parallel grooves and shallow vees, etc, see Figure 12.

Skew — used to make vees, beads, etc., see Figure 12.

Square Scraper — used for diameter scraping and featureless scraping, etc, see Figure 12.

Large Domed Scraper — used to reduce ridges on the interior of bowls, round edges of bowls, etc, see Figure 12.

Parting Tool — used to cut directly into the material, or to make a cut off. Also used for scraping and to set diameters, see Figure 12.

For safety and best performance, keep tools sharp. If a tool stops cutting, or requires excessive pressure to make a cut, it needs to be sharpened. A number of brand name sharpening jigs and fixtures are available, however, a woodturner should learn to sharpen tools freehand.

13