ACDelco PN 09301 A manual Installation, Location, Fuel Supply, Venting the Units

Page 6

INSTALLATION

1. LOCATION

Avoid operating units in small areas or near exhaust fans. Adequate oxygen is needed for combustion or dangerous carbon monoxide will result. Stationary units should be installed in accordance with local plumbing and heating codes.

2. FUEL SUPPLY

Oil Fired Units: Fill fuel tank with clean kerosene, No. 1 home heating fuel, or diesel fuel (without anti-gel additives.)

3. VENTING THE UNITS -

If the unit is to be used in an enclosed area it must be vented out.

The Draft Regulator (on oil-fired units) and chimney must be same size as the stack on the cleaner unit. Poor draft will cause the unit to soot-up and not operate efficiently. When installing the machine so the stack will be as straight as possible, protruding through the roof at a sufficient height to eliminate down-draft and to comply with local codes.

Always disconnect the battery when servicing your cleaner.

Manual

Page 6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents King Brute Limited Warranty Limited Warranty Important Safety Precautions DO’SHOT Fuel Supply InstallationLocation Venting the UnitsOperating the Machine PRE-OPERATING InstructionsOperating Instructions Shut Down Instructions Things to Check DailyThings to Check Weekly Maintenance of Components PumpsOIL Burners Winterizing DE-SOOTING Coil DE-LIMING or DE-SCALING of CoilDiagnosis and Maintenance Problem Probable Cause SolutionManual PUM0015 PPA0015 Unloader Burner Beckett 12V Component Locator & Parts List Electrical Schematic 12VDC Gunvalve and Hose Assembly Component Locator Gunvalve and Hose Assembly Component Locator Parts List GC 590-40 Gunvalve Component Locator GC 590-40 Gunvalve Component Locator Parts List
Top Page Image Contents