8.Press the Gun Trigger [B.7] so the air and any extra pressure are expelled from the piping.
9.Connect the Plug to the Socket [B.8].
10.Start the equipment by turning the O/I Switch into the “I” position.
Warning: Risk of Injection: Unit will start spraying when trigger is squeezed if O/I Switch is in the “I” position. Once Switch is returned to the Off position, pressure still exists inside the unit. Therefore, be sure to point the Gun in a safe direction at all times, whether the unit is On or Off. Do not discharge stream directly at any person or animal.
Whenever you need to stop the machine, be sure to use the Safety Lock on the Gun, to avoid unintentional starting.
11.Electric Motor: The Electric Motor is equipped with a Thermal Switch. The Motor will stop if it overheats. If this occurs, wait
12.Adjusting the Spraying Jet: Turn the knob at the end of the Wand in either direction to obtain a straight or fan spray.
13.Using Foaming Lance: Attach Foaming Lance to the Gun as shown in Diagram C below. Turn on the Washer. Suction and mixing will occur automatically as the water flows through the Lance and the Detergent Container.
Diagram C
SKU 45802 | Page 8 |