
IMPORTANT BASICS REGARDING ELECTRIC PRESSURE WASHERS
1.All connections must be tight. If there is water leaking out, air can also leak in. Make sure the water supply is fully on.
2.Check the inlet strainer for any blockage, including packaging debris. Most washers are shipped with a plastic plug in the inlet.
3.The washer will not pressurize if the nozzle is not completely assembled. It will not work properly with only part of the wand installed.
4.It may take a few
5.Minerals in the water can harden inside the workings. Flush the unit with automotive antifreeze prior to
6.The Foaming Lance creates foam. There is much less pressure when using the Foaming Lance.
Moving and Storage
This unit is equipped with wheels, so it can be easily moved.
Store the Pressure Washer indoors. If you are keeping the machine in an environ- ment where there is danger of ice or frost forming on the unit, or if you do not use the product for more than 3 months, we suggest you add an antifreeze solution (similar to that used in automobiles) before putting it away. When you start the machine up again, slight leakage can occur. This leakage will disappear once the machine has been in operation for a few hours.
Be careful not to damage the Electric Cable. If the Cable does become damaged, replace it with an identical replacement Cable. Only professionally qualified personnel may be allowed to replace the Electric Cable.
Maintenance
Your Pressure Washer is supplied with a closed lubrication system, so you do not need to add oil. Check periodically for any deposits that might potentially clog the system.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFAC- TURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS RE- PLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 45802 | Page 9 | REV 04/04 REV 09/03 |