To Attach Accessories:
1.Before using the Washer, fit the Wand [A.2] and Lance [A.3] to the Gun [A.1]: Insert the shaped tip of the Wand into the hole of the Gun, paying attention to join the notch. Press the Wand lightly towards the Gun, and rotate it in the direction of the arrows, as far as it will turn, as shown in Diagram A below.
2.Follow the same instructions to attach the Lance or the Foaming Lance [A.4] to the Gun.
Diagram A
To Operate:
1.Use only cold water.
2.Check the GFCI Plug and Cord before connecting the system. Plug the power cord into a grounded 120v outlet and press the reset button on the plug.
THIS MUST BE DONE EACH
TIME THE UNIT IS PLUGGED | Diagram B |
INTO AN OUTLET. |
|
Warning: Test the GFCI Plug before each use. Plug the GFCI plug into a power outlet. The Indicator should turn red. Press the Test button. The Indicator light should disappear. Press Reset button again before use. Do not use this product if the above test fails.
3.Check to see that the O/I Switch [B.1] is in the “O” position.
4.Connect the Water Service Pipe [B.2] to the Suction Pipe Fitting Inlet [B.4] using a siphoned tube (min. 15bar/200psi) with an inside diameter of at least 13 mm (1/2”).
5.Attach the Lance to the Spray Gun.
6.Connect the
7.Open the Water Valve [B.3] completely.
SKU 45802 | Page 7 |