•Units with broken Ormissing parts,or without protective housing or covers should NEVER be operated.
•The muffler and air cleaner must be installed and in good conditionbefore operating the Pressure Washer. These components act as spark arrestors if the engine backfires.
•Check the fuel system for leaks or signs of deteri- oration such as chafed or spongy hose, loose or missing clamps or damaged tank or cap. Correct
all defects before operating the Pressure Washer.
OPERATION:
•Do not spray flammable liquids.
•Never allow any,part of the bod.y..._come in con- tact with the flu_ostream, uu NU/come in con-
tact with a fluid stream created by a leak in the high pressure hose.
•High pressure stream of fluid that this equipment can produce can pierce skin and its underlying tissues, leading to serious injury and possible amputation.
•Never aim the gun at people, animals or plants.
•High pressure spray can cause paint chips or other joarticlesto become airborne and fly at high speeos.
•Always wear eye protection when you use this equipment or when you are in the vicinity where the equipment is in use.
•Operate the pressure at no more than the PSI fluid pressure rated for your pressure washer.
•Never move the machine by pulling on the high pressure hose. Use the handle provided on the top of the unit.
•Always be certain the spray gun, nozzles and accessories are correctly attached.
•Never use a spray gun which does not have a trigger lock or trigger guard in place and in work- ing order.
•Use a respirator or mask whenever there is a chance that vapors may be inhaled. Read all instructions with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors.
•Highpressure spray may damage fragile items including glass. Do not point spray gun at glass when in the jet spray mode.
•Keep the hose connected to machine or the spray gun while the system is pressurized. Disconnecting the hose while the unit is pressur- ized is dangerous.
•Hold the spraygun firmly in your hand before you start the unit. Failure to do so could result in an injury from a whipping spray g.un. Do not leave the spray gun unattended while the machine is running.
•The cleaning area should have adequate slopes and drainage to reduce the possibility of a fall due to slippery surfaces.
•Keep water spray away from electric wiring or fatal electric shock may result.
•Do not adjust unloader valve to a pressure in excess of machine rating.
•Do not secure trigger gun in the
•Do not
•The muffler and engine heat up during operation and remain hot immediately after shutting it down. Avoid contact with a hot muffler or engine or you could be severely burned.
MAINTENANCE AND STORAGE:
•Operate and store this unit on a stable surface.
•High pressure hose can develop leaks from wear, kinking, abuse, etc. Water spraying from a leak is capable of injecting material into skin.Inspect hose each time before using it. Check all hoses for cuts, leaks, abrasions or bulging of cover, or damage or movement of couplings. If any of these conditions exist, replace hose immediately. Never repair high pressure hose. Replace it with another hose that meets minimum pressure rat- ing of your pressure washer.
Note: In the State of California a spark arrestor is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.
Note: If you equip the engine of your pressure wash- er with a spark arrestor muffler, the spark arrestor must be maintained in effective working order by the owner/operator.
You can order a spark arrestor (part # 398067) through your Sears Service Center.
LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. I
IT MEANS "ATrENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED."