HOW TO USE YOUR PRESSURE WASHER • Twistingthe nozzle adjusts the spray pattem from a narrow pattern to a fan pattern.
IF YOU HAVE ANY PROBLEMS operating your pres- sure washer, please call the pressure washer helpline at
A WARNING NEVER adjust spray pattern when spraying. NEVER put hands in front of spray nozzle to adjust spray pattern.
You could be injured.
HOW TO ADJUST PRESSURE AND SPRAY PATrERN
On the end of yourspray gun is a nozzle that you can slide forward and backward and that you can also twist from side to side. With the adjustable noz- zle you can adjust the spray pattern to be either high pressure or low pressure. You can also adjust the spray so it is concentrated in a stream pattern or expanded into a fan pattern.
•Located on the front of the pump is the pressure control knob. You can increase the pressure of the spray by turning the knob clockwise or decrease the pressure by turning the knob coun-
terclockwise,
TWIST NOZZLE | TWIST NOZZLE FOR |
FOR FAN SPRAY | NARROW SPRAY |
PATTERN | PATTERN |
between 8 to 24 inches away from cleaning sur-
face.
i For most effective cleaning, keep spray nozzle
If you get spray nozzle too close, especially using high pressure mode, you may damage the clean- ing surface.
APPLYING DETERGENT AND CLEANING WITH
ADJUSTABLE NOZZLE
Slide the nozzle forward when you wish to adjust the spray to low pressure mode. Slide the nozzle backward to achieve high pressure (see "Adjusting the Spray Pattern in figure below).
IMPORTANT: Use soaps designed specificallyfor pressure washers. Household detergents could dam- age the pump.
IMPORTANT: You must attach all hoses before you start the engine. Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
Note: The first step involves applying an appropriate detergent/solvent solution to penetrate and loosen grime. The detergent is applied at low pressure to avoid splashing, overspraying and waste. Leave the solutionon surface for 3 to 5 minutes to allow solu- tion to work.
Note: The second step involves cleaning the surface
you have prepared with the pressure washe r and then rinsing it clean.
NOZZLE IN HIGH SLIDE NOZZLE FORWARD
PRESSURE MODE FOR LOW PRESSURE MODE AND DETERGENT APPLICA- TION