AFTER EACH USE
Water should not remain in the unit for long periods of time. Sediments of mineralscan deposit on pump parts and "freeze" pump action. Follow these procedures after every
Use:
•Flush detergent hose by placing the injector filter into a pail of clear water while running Pressure Washer with nozzle in low pressure mode. Flush until you can see clear water running through the tube.
•Shut off the engine and let it cool, then remove all hoses.
A CAUTION: Be sure throttle lever is in "STOP" position before you continue. If you start engine without the proper water supply connected, you can damage the pump.
Empty the pump of all pumped liquids by pulling recoil handle about 6 times. This should remove most of the
liquid in the pump.
Coil the high pressure hose and inspect it for damage. Cuts in the hose or fraying of it could result in leaks and loss of pressure. Should any damage be found, replace the hose. DO NOT attempt to repair a dam- aged hose. Replace the hose with the genuine Craftsman part.
Drain water from hose and properly hang it on the wire support provided on the guide handle.
Note: To protect the unit from freezing temperatures, you can draw windshieldwasher fluid into the pump by pour-
ing the washer fluid into a
•Store in a clean, dry area.
A WARNING: NEVER store engine with fuel in tank indoors or in enclosed, poorly venti- lated areas where fumes may reach an open flame, spark or pilot light as on a fur- nace, water heater, clothes dryer or other gas appliance.
LONG TERM STORAGE
If you do not plan to use the PressureWasher for morethan 30 days, you mustpreparethe enginefor longterm storage.
Note: As always, prepare the pressure washer pump as you would after each use.
It is important to prevent gum deposits from forming In essential fuel system parts such as the carburetor, fuel fil- ter, fuel hose or tank during storage. Also, experience indicates that
To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Follow these instructions:
PROTECT FUEL SYSTEM
•Remove all gasoline from the fuel tank to prevent gum deposits from forming on these parts and causing pos- sible malfunction of engine.
_1_ WARNING: Drain fuel into approved con- tainer outdoors, away from open flame. Be sure engine is cool. Do not smoke.
•Run engine until engine stops from lack of fuel. Make
sure you have water supply to pump inlet connected and turned ON.
CHANGE OIL
While engine is still warm, drain oil from crankcase. Refill
with recommended grade.
OIL CYLINDER BORE
•Remove spark plug and pour about 1/2 ounce (15ml) of engine oil into the cylinder. Cover spark plug hole with rag. Crank slowly to distribute oil.
I A CAUTION!hole when crankingAvoid sprayenginefromslowlyspark. plug IJ
•Install spark plug. Do not connect spark plug wire.
OTHER
Do not store gasoline from one season to another.
Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.
If possible, store your unit indoors and cover it to give protection from dust and dirt. BE SURE TO EMPTY
THE FUEL TANK.
•Cover your unitwith a suitable protective._overthat does not retain moisture.
IMPORTANT: NEVER cover your pressure washer while engine and exhaust area are warm.