IMPORTANT:Itisimportantto preventgumdeposits fromforminginessentialfuelsystempartssuchasthe carburetor,fuelfitterhoseor tank during storage. Also,
'_._xperienceJndioates that alcohoFblended fueJs (¢atled
'gasohoior using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage, To avoid engine problems, the fuel system shouJd be emptied before storage of 30 days or longer. Never use engine or carburetor cleaner prod_Jcts in the fuel tank or permanent damage may occur,
I
water source turned on and connected to pressure_ i A CAUTION, Never start pressure washer with out
washer,j
To Start Your Pressure Washer
Make sure fue! shutoff valve is turned to the open position
FUEL SHUTOFF" | __ | _'_\! |
VALVE |
|
|
•Remove gas cap
.. Add unleaded gasoline, slowly, to fuel tank.
•Do not overfill.
•Connect garden hose to the water inlet on the pressure washer. Tighten by turning water inlet counterclockwise..
- Connect high pressure hose to discharge on pump,,
*Connect the garden hose to the water spout and turn water supply on.
-Squeeze trigger on pressure washer wand to relieve air
pressure caused by turning on the water_ Water will spew out of the gun in a thin stream, This will make it easier to start the engine.
,Engage the safety latch on the spray gun, This locks the trigger in place and keeps you from accidentally spraying a high pressure stream.
•On the engine there is a choke/run tever, Place lever to the choke position.
,On the engine there Is a throttle control lever. Place throttle to the rabbit position. Always start engine with throttle In the rabbit position. Place on/stop switch to the "on" postton.
• Make sure fuel shut off valve is to the on position.
o Grasp the starter grip and pull slowly until resistance is felt, then pull firmly to start engine.
•When engine starts, grac_ual]y move choke lever to RUN position.
°If engine does not start after 5 pulls, place choke back to run position.
•For hot engine starts make sure choke/run lever is in the run position, Make sure fuel shut off valve is open and throttle is in the Rabbit position.
NOTE: if any leaks are present shtrt unit down and tighten fittEngs.
to