Tools Required | for Assembly | 2_ | Remove wood plank from the frame of the unit,, | |
Adjustable | wrench |
|
| An adjustable wrench ts required, Discard bolt |
|
| and board. | ||
t/2" Socket |
|
|
| |
|
|
|
| |
_ernove | Pressure | Washer from | Carton |
|
,Open carton from the top.. Locate and remove from oat'ton,the parts box, which includes gun, handle, wand,oil, knobs and bo]ts. Next remove the parts bag and the handle,,
•Cut carton along dotted lines.. Remove all carton inserts.
-Roll unit through opening in carton.
Note; The pressure and chemical hose are located at the bottom of the box.
Preparing the Pressure Washer for First Use
Note: Included wffh your pressure washer is a video tape on how to prepare your unit for operation, it is recommended you view this tape before performing the next steps.
1.insert handle onto frame,
°Insert knobs into the threaded slot in front of the
frame handle and tighten by turning in a clockwise direction.
o Slide bolts into the slot in the side of the frame
handle and tighten the nut by turning in a clockwise direction.
3.Mount the rubber isolator to the frame,,
*To mount isolator place threaded end of bolt through the washer,.
°Next with washer on bolt place threaded end of bolt through larger hole in bottom of the rubber isolator,, Place _.hreaded portion of isolator through the frqnt hole location where
the wood plank was mounted on the pressure washer.
,Next plaoe lockwasher over threaded portion of bolt that has been placed through the mounting hole in the pressure washer and use nut to tighten isolator to the frame°
o Tighten nut with an adjustable wrench..
n t_L11"
pa_sul_l L0._/ .
4.Connect wand with nozzle assembly to gun.. To tighten, turn knob in clockwise direction. Hand tlghten_