Checklist Before Starting

Slowlyaddfueltofueltank.Usea funnelto preventspillageFilltankto. about1.5"belowtop of thefillerneck.

Fuel

Install fuel cap and wipe up any spilled fuel.

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts, such as

the carburetor, fuel filter, fuel hose or tank during storage. Also, experience indicates that alcohol-blended fuels (called gasohol, ethanol or

methanol) can attract moisture, which leads to separation and formation of acids during storage.

Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. See "Storage _ on pages 16-17. NEVER use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Connect Hose and Water Supply to Pump

IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.

1.Uncoil high pressure hose and attach one end of hose to base of spray gun. Tighten by hand.

	Inspect	inlet
J	screen;	DO
, _;':_:i:_:./_	NoT use if
.-	aa agea	cea
	if di_.

Run water through garden hose for 30 seconds to flush it of debris. Turn off water.

IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).

6.Connect garden hose (net to exceed 50 feet in length) to water inlet. Tighten by hand.

this instruction will void warranty

7.Turn ON water and squeeze trigger on spray gun to purge pump system of air and impurities.

wear!rig adequate eye protection:

2.Remove and discard shipping caps from pump inlet and outlet.

3.Attach other end of high pressure hose to high pressure outlet on pump. Tighten by hand.

4.Before connecting garden hose to water inlet, inspect inlet screen. Clean screen if it contains debris or have it replaced if damaged. DO NOT run pressure washer if inlet screen is damaged,

ENGINE

Review the assembly to ensure you have performed all of the following:

1.Check that oil has been added to proper level in engine crankcase.

2.Add proper fuel to fuel tank.

3.Check for properly tightened hose connections (high pressure and water supply) and for tight connections and that there are no kinks, cuts, or damage to the high pressure hose.

4.Provide proper water supply (net to exceed 100=F).

5.Be sure to read "Safety Rules" and "Operation" sections before using the pressure washer.

6.If starting unit after storage, see "Sterage" section on pages 16-17.