Customer Responsibilities, Before Each USE

CUSTOMER		RESPONSIBILITIES
MAINTENANCE SCHEDULE
FILL IN DATES AS YOU COMPLETE	HOURLY	OPERATING INTERVAL	SERVICE DATES
REGULAR SERVICE

MAINTENANCE TASK

PRESSURE WASHER Check/cleaninletfilter and screen

Check high pressurehose.

Check detergenthose.

Check gun and wand for leaks.

Check pumpoil.

Purgepumpof air and contanirnents

ENGINE

Check oil level,

Change engine oil. _,

Retorque head bolts.

Service air cleaner.

CtearVreplacespark plug.

Clean spark arrestor screen.

Prepare for storage,

	Every25	Every50	Every100
Before	Hours or	Hours or	Hoursor
Each Use	Yearly	Yearly	Yearly
xv
x
x
x
		x
x
x
		x*
		x
	X**
			x
			x

Prepare unit for storage if it is to remain idle

longer than 30 days

V Clean if dogged, Replace if perforated or torn

_, Change oil after first 8 hours, then after every 50 hours_

" Change sooner when operating und_ heavy load or high arabic nt temperature ** Clean more often under dusty conditions or when alrbome debris is present

GENERAL RECOMMENDATIONS

The warranty of the high pressure washer does not cover items that have been subjected to operator abuse or neg-

ligence. To receive full value from the warranty, operator must maintain high pressure washer as instructed in this manual

Some adjustments will need to be made periodically to properly maintain your high pressure washer.

All adjustments in the Service and Adjustments section of this manual should be made at least once each season.

oOnce a year you should replace the spark plug and clean or replace the air filter and check the gun and wand assembly for weal A new spark plug and clean air filter assure proper fuel-air mixture and help your ertgine run better and last longer.

BEFORE EACH USE

o Check engine oillevel.

=Check water inlet filter and quick-connect screen for damage_

1, Check high pressure hose for leaks.

oCheck detergent inlet hose and filter for damage. ,, Check gun and wand assembly for leaks.

,, Purge pump of air and contaniments.

PRESSURE WASHER MAINTENANCE

Check and Clean Inlet Supply Filter and Inlet Screen" Remove quick-connect and examine inlet screen on trie female connector and filter on pump inlet fitting. Clean if either is clogged or replace if either is torn.

Check High Pressure Hose: High pressure hose can

develop leaks from wear, kinking, abuse. Inspect hose each time before using iL Check for cuts, leaks, abrasions

or bulging of cover, or damage or movement of couplings. If an_yof these conditions exist, replace hose immediately_

&DANGER: WATER SPRAYING FROM A LEAK IS CA-]

PABLE OF INJECTING MATERIAL INTO SK]FL NEVER

REPAIR HIGH PRESSURE HOSE, REPLACE WITH HOSETHAT MEETS MINIMUM PRESSURE RATING OF

YOUR PRESSURE WASHER.

Check Detergent Hose: Examine the filter on the deter- gent hose and clean if clogged_ Hose should fit tightly on barbed fitting, Examine hose for leaks or tears, Replace the filter or'hose if either is damaged.

Check Gun and Wand: Examine hose connection to gun and make sure it is secure. Test trigger by pressing it and making sure it springs back into place when you release it. Put safety latch in ON position and test trigger. You should not be able to press trigger.

Check Pump Oil: Refer to PUMP MAINTENANCE for information.

CUSTOMER

RESPONSIBILITIES