To Assemble Remaining Components, Pump

ASSEMBLY

,,Attach wire basket to bent arms of support legs with #10 self-drilling screws (Fig_ 4) using 5/16" (6ram) wrench. The gun holder should be positioned to the left. Be sure loop of support is pointing upward.

eUnravel high pressure hose, remove protective cap from end of hose and check other end of hose to see that threads are properly covered with teflon tape. If tape is not properly applied, reapply it so threads are fully covered. The tape seals the connection from hose to gun and wand assembly.

Attach fitting with teflon tape to gun and wand assembly (Fig. 7). You may want to spin gun_ Tighten with 7/8" wrenches or adjustable wrenches.

SUPPORT

FIG. 4

TO ASSEMBLE REMAINING COMPONENTS

IMPORTANT: YOU MUST ASSEMBLE WAND AND AT- TACH ALL HOSES BEFORE YOU START ENGiNE,

STARTING ENGINE WITHOUT ALL HOSES CON- NECTED AND WATER SUPPLIED WILL DAMAGE

PUMP.

,,Remove cap from top of pump and insert oi/fill cap included in parts bag

(Fig. 5).

FIGo5

Included with this unit is a Quick-Connect fitting you attach to Water Inlet on pump. The quick-connect includes two parts -- a Male Connector factory-in- stalled on water inlet and a Female Connector (Fig 6). Remove male connector to inspect Intake Supply Screen in water inlet for cleanliness and inspect Inlet Screen on female connector, Install male connector to water inlet and attach female connector to garden hose.

INTAKE SUPPLY OPENING

INTAKE SUPPLY FILTER

_	FEMALE CONNECTOR

MALE CONNE

INLET SCREEN

FIG. 6

HG. 7

Attach the other end of the high pressure hose to high pressure fitting on pump (Fig. 8) Tighten with adjust- able wrench,

DETERGENT PICKUP TUBE AND FILTER

!,	HIGH PRESSURE HOSE

FIG. 8

*Unravel Detergent Pickup Tube and place filter in basket°

IMPORTANT: KEEP DETERGENT PICKUP TUBE AWAY FROM HOT MUFFLER,

,= Attach Detergent Pickup Tube as shown in Fig. 8_

,,To attach the adjustable nozzle, refer to Operation section, Fig. 11.

CHECKLIST

oCheck that fasteners you used to install wheels and handle are tight. Vibration dudng operation may loosen fasteners that are not tight enough.

•Check for proper hose connections (high pressure and water supply) and for tight connections and that there are no kinks, cuts, or damage to the high pressure hose.

=Provide proper water supply (not to exceed 140°F).

oBe sure to read "Safety Rules" and "Operation" sec- tions before using the pressure washen