Delta instruction manual D29382 ENG

Page 10

4.Remove the cleaning solution application tank from the application nozzle. a

5.Soap mixture pressure can be adjusted by adjusting the pipe located in the cleaning solution application nozzle (a).

a. Pull pipe (b) from cleaning solution application nozzle.

b

b.Position the notch (c) on the pipe to the desired soap mixture 1-6, 1 being the highest and 6 being the lowest.

c

c.Press pipe into position.

6.Fill application tank with detergent.

7.Push cleaning solution application tank onto cleaning solution application nozzle. Turn to lock into place.

8.See Before Starting and Starting Your Pressure Washer paragraphs in this section to continue.

D29382

10- ENG

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Instruction Anum AL Safety Guidelines Definitions Risk of Electrical ShockRisk of Explosion or Fire Risk to BreathingRisk of Unsafe Operation Risk of HOT SurfacesExtension Cords Ground Fault Circuit Interrupter ProtectionGrounding Instructions Risk of Injury from SprayCarton Contents Assembly Instructions Operating Instructions ON-OFFHOW to USE Spray Wand HOW to USE the Cleaning Solution Application UnitD29382 ENG Read and Understand ALL Warnings Before Starting Unit Before StartingStarting Your Pressure Washer Shutting Down Your Pressure Washer MaintenanceRecommended Cleaning Suction FilterD29382 ENG When Freezing Temperatures are Expected StorageTrouble Shooting Guide Problem Cause CorrectionENG D29382 Warranty Responsibility of Original Purchaser initial User
Top Page Image Contents